|
MJE18006 Datasheet, PDF (8/10 Pages) Motorola, Inc – POWER TRANSISTOR 6.0 AMPERES 1000 VOLTS 40 and 100 WATTS | |||
|
◁ |
MJE18006 MJF18006
TEST CONDITIONS FOR ISOLATION TESTS*
MOUNTED
CLIP FULLY ISOLATED
PACKAGE
LEADS
MOUNTED
CLIP
FULLY ISOLATED
PACKAGE
0.107â³ MIN
LEADS
MOUNTED
FULLY ISOLATED
PACKAGE
0.107â³ MIN
LEADS
HEATSINK
0.110â³ MIN
HEATSINK
Figure 22a. Screw or Clip Mounting Position Figure 22b. Clip Mounting Position
for Isolation Test Number 1
for Isolation Test Number 2
* Measurement made between leads and heatsink with all leads shorted together
HEATSINK
Figure 22c. Screw Mounting Position
for Isolation Test Number 3
MOUNTING INFORMATION**
4â40 SCREW
CLIP
PLAIN WASHER
HEATSINK
COMPRESSION WASHER
NUT
HEATSINK
Figure 23a. ScrewâMounted
Figure 23b. ClipâMounted
Figure 23. Typical Mounting Techniques
for Isolated Package
Laboratory tests on a limited number of samples indicate, when using the screw and compression washer mounting technique, a screw
torque of 6 to 8 in . lbs is sufficient to provide maximum power dissipation capability. The compression washer helps to maintain a
constant pressure on the package over time and during large temperature excursions.
Destructive laboratory tests show that using a hex head 4â40 screw, without washers, and applying a torque in excess of 20 in . lbs will
cause the plastic to crack around the mounting hole, resulting in a loss of isolation capability.
Additional tests on slotted 4â40 screws indicate that the screw slot fails between 15 to 20 in . lbs without adversely affecting the pack-
age. However, in order to positively ensure the package integrity of the fully isolated device, Motorola does not recommend exceeding 10
in . lbs of mounting torque under any mounting conditions.
** For more information about mounting power semiconductors see Application Note AN1040.
8
Motorola Bipolar Power Transistor Device Data
|
▷ |