M68ICS08KX Datasheet, PDF (60/77 Pages) Motorola, Inc – In-circuit Simulator Board

Quick Start Hardware Configuration Guide
Installing the Hardware
B.1.2 Target Interface Cable Connections
Below (Table 4-4) is a quick reference for defining the cable/connector setup to
use with the MC68HC908KX8
Table 4-3 Cable/Connector Options for MCUs
MCU
Flex Cable
Ribbon
Cable
MC68HC908KX8
J1
J5
MON08
Cable
J3
B.1.3 Host Computer — KXICS Interconnection (J6)
Connect the DE9 serial cable. Connect one end of this cable to your host PC and
the other end to connector J6 on the KXICS board.
B.2 Installing the Hardware
For installing Motorola development tools, the following steps provide
installation instructions for the KXICS hardware.
To prepare the KXICS (Figure 2-1) for use with a host PC:
1. Install an MCU (DIP or SOIC) into the KXICS board.
DIP-type MCU:
a. Place the pin tension arm of the KXICS DIP socket XU1 in the up
position.
b. Install the DIP type MCU into the DIP socket XU1. Be sure that the
pin 1 orientation of the silkscreened dot on the MCU aligns with the
pin 1 location on the DIP socket (upper left pin of the socket) .
c. Place the pin tension arm of the KXICS DIP socket XU1 in the
down position to secure the pins of the MCU to the socket.
NOTE: The top (label side) of the MCU package must be visible when looking at the
component side of the board.
SOIC-type MCU:
M68ICS08KX In-Circuit Simulator
MOTOROLA
Quick Start Hardware Configuration Guide
User’s Manual
55