TCA0372 Datasheet, PDF (2/8 Pages) Motorola, Inc – Dual Power Operational Amplifier

TCA0372
MAXIMUM RATINGS
Rating
Supply Voltage (from VCC to VEE)
Input Differential Voltage Range
Input Voltage Range
Junction Temperature (Note 2)
Storage Temperature Range
DC Output Current
Peak Output Current (Nonrepetitive)
Symbol
Value
Unit
VS
40
V
VIDR
(Note 1)
V
VIR
(Note 1)
V
TJ
+150
°C
Tstg
–55 to +150
°C
IO
1.0
A
I(max)
1.5
A
DC ELECTRICAL CHARACTERISTICS (VCC = +15 V, VEE = –15 V, RL connected to ground, TJ = –40° to +125°C.)
Characteristics
Symbol
Min
Typ
Max
Unit
Input Offset Voltage (VCM = 0)
VIO
TJ = +25°C
TJ, Tlow to Thigh
Average Temperature Coefficient of Offset Voltage
∆VIO/∆T
Input Bias Current (VCM = 0)
IIB
Input Offset Current (VCM = 0)
IIO
Large Signal Voltage Gain
VO = ±10 V, RL = 2.0 k
AVOL
Output Voltage Swing (IL = 100 mA)
TJ = +25°C
TJ = Tlow to Thigh
TJ = +25°C
TJ = Tlow to Thigh
VOH
VOL
Output Voltage Swing (IL = 1.0 A)
VCC = +24 V, VEE = 0 V, TJ = +25°C
VCC = +24 V, VEE = 0 V, TJ = Tlow to Thigh
VCC = +24 V, VEE = 0 V, TJ = +25°C
VCC = +24 V, VEE = 0 V, TJ = Tlow to Thigh
VOH
VOL
Input Common Mode Voltage Range
TJ = +25°C
TJ = Tlow to Thigh
VICR
Common Mode Rejection Ratio (RS = 10 k)
CMRR
Power Supply Rejection Ratio (RS = 100 Ω)
PSRR
Power Supply Current
ID
TJ = +25°C
TJ = Tlow to Thigh
NOTES: 1. Either or both input voltages should not exceed the magnitude of VCC or VEE.
2. Power dissipation must be considered to ensure maximum junction temperature (TJ) is not exceeded.
—
1.0
15
—
—
20
—
20
—
—
100
500
—
10
50
30
100
—
14.0 14.2
—
13.9
—
—
—
–14.2 –14.0
—
—
–13.9
22.5 22.7
—
22.5
—
—
—
1.3
1.5
—
—
1.5
VEE to (VCC –1.0)
VEE to (VCC –1.3)
70
90
—
70
90
—
—
5.0
10
—
—
14
mV
µV/°C
nA
nA
V/mV
V
V
V
dB
dB
mA
AC ELECTRICAL CHARACTERISTICS (VCC = +15 V, VEE = –15 V, RL connected to ground, TJ = +25°C, unless otherwise noted.)
Characteristics
Symbol
Min
Typ
Max
Unit
Slew Rate (Vin = –10 V to +10 V, RL = 2.0 k, CL = 100 pF)
AV = –1.0, TJ = Tlow to Thigh
SR
1.0
1.4
—
V/µs
Gain Bandwidth Product (f = 100 kHz, CL = 100 pF, RL = 2.0 k)
TJ = 25°C
TJ = Tlow to Thigh
GBW
0.9
1.4
—
0.7
—
—
MHz
Phase Margin TJ = Tlow to Thigh
RL = 2.0 k, CL = 100 pF
φ_m
—
65
—
Degrees
Gain Margin
RL = 2.0 k, CL = 100 pF
Am
—
15
—
dB
Equivalent Input Noise Voltage
RS = 100 Ω, f = 1.0 to 100 kHz
en
—
22
—
nV/√ Hz
Total Harmonic Distortion
AV = –1.0, RL = 50 Ω, VO = 0.5 VRMS, f = 1.0 kHz
THD
—
0.02
—
%
NOTE: In case VEE is disconnected before VCC, a diode between VEE and Ground is recommended to avoid damaging the device.
2
MOTOROLA ANALOG IC DEVICE DATA