SN54LS290 Datasheet, PDF (1/7 Pages) Motorola, Inc – DECADE COUNTER; 4-BIT BINARY COUNTER

DECADE COUNTER;
4-BIT BINARY COUNTER
The SN54 / 74LS290 and SN54/ 74LS293 are high-speed 4-bit ripple type
counters partitioned into two sections. Each counter has a divide-by-two sec-
tion and either a divide-by-five (LS290) or divide-by-eight (LS293) section
which are triggered by a HIGH-to-LOW transition on the clock inputs. Each
section can be used separately or tied together (Q to CP)to form BCD,
Bi-quinary, or Modulo-16 counters. Both of the counters have a 2-input gated
Master Reset (Clear), and the LS290 also has a 2-input gated Master Set
(Preset 9).
• Corner Power Pin Versions of the LS90 and LS93
• Low Power Consumption . . . Typically 45 mW
• High Count Rates . . . Typically 42 MHz
• Choice of Counting Modes . . . BCD, Bi-Quinary, Binary
• Input Clamp Diodes Limit High Speed Termination Effects
CONNECTION DIAGRAM DIP (TOP VIEW)
VCC MR MR CP1 CP0 Q0 Q3
14 13 12 11 10 9
8
LS290
NOTE:
The Flatpak version
has the same pinouts
(Connection Diagram) as
the Dual In-Line Package.
1
2
3
4
5
6
7
MS NC MS Q2 Q1 NC GND
VCC MR MR CP1 CP0 Q0 Q3
14 13 12 11 10 9
8
LS293
SN54/74LS290
SN54/74LS293
DECADE COUNTER;
4-BIT BINARY COUNTER
LOW POWER SCHOTTKY
14
1
J SUFFIX
CERAMIC
CASE 632-08
14
1
14
1
N SUFFIX
PLASTIC
CASE 646-06
D SUFFIX
SOIC
CASE 751A-02
ORDERING INFORMATION
SN54LSXXXJ
SN74LSXXXN
SN74LSXXXD
Ceramic
Plastic
SOIC
1
2
3
4
5
6
7
NC NC NC Q2 Q1 NC GND
PIN NAMES
LOADING (Note a)
CP0
CP1
CP1
MR1, MR2
MS1, MS2
Q0
Q1, Q2, Q3
Clock (Active LOW going edge) Input to ÷ 2 Section.
Clock (Active LOW going edge) Input to ÷ 5 Section (LS290).
Clock (Active LOW going edge) Input to ÷ 8 Section (LS293).
Master Reset (Clear) Inputs
Master Set (Preset-9, LS290) Inputs
Output from ÷ 2 Section (Notes b & c)
Outputs from ÷ 5 & ÷ 8 Sections (Note b)
HIGH
0.05 U.L.
0.05 U.L.
0.05 U.L.
0.5 U.L.
0.5 U.L.
10 U.L.
10 U.L.
LOW
1.5 U.L.
2.0 U.L.
1.0 U.L.
0.25 U.L.
0.25 U.L.
5 (2.5) U.L.
5 (2.5) U.L.
NOTES:
a) 1 TTL Unit Load (U.L.) = 40 µA HIGH/1.6 mA LOW.
b) The Output LOW drive factor is 2.5 U.L. for Military (54) and 5 U.L. for Commercial (74) Temperature Ranges.
c) The Q0 Outputs are guaranteed to drive the full fan-out plus the CP1 Input of the device.
FAST AND LS TTL DATA
5-466