MURB1660CT Datasheet, PDF (1/6 Pages) Motorola, Inc – ULTRAFAST RECTIFIER 16 AMPERES 600 VOLTS

MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MURB1660CT/D
™ Designer's Data Sheet
SWITCHMODE™ Power Rectifier
D2PAK Power Surface Mount Package
Designed for use in switching power supplies, inverters and as free wheeling
diodes, these state–of–the–art devices have the following features:
• Package Designed for Power Surface Mount Applications
• Ultrafast 60 Nanosecond Recovery Times
• 175°C Operating Junction Temperature
• Epoxy Meets UL94, VO @ 1/8″
• High Temperature Glass Passivated Junction
• High Voltage Capability to 600 V
• Low Leakage Specified @ 150°C Case Temperature
• Short Heat Sink Tab Manufactured – Not Sheared!
• Similar in Size to Industrial Standard TO–220 Package
1
Mechanical Characteristics
3
• Case: Epoxy, Molded
• Weight: 1.7 grams (approximately)
• Finish: All External Surfaces Corrosion Resistant and Terminal
Leads are Readily Solderable
• Lead and Mounting Surface Temperature for Soldering
Purposes: 260°C Max. for 10 Seconds
• Shipped 50 units per plastic tube
• Available in 24 mm Tape and Reel, 800 units per reel by
adding a “T4” suffix to the part number
• Marking: U1660T
MURB1660CT
Motorola Preferred Device
ULTRAFAST RECTIFIER
16 AMPERES
600 VOLTS
4
4
1
3
CASE 418B–02
D2PAK
MAXIMUM RATING, PER LEG
Rating
Peak Repetitive Reverse Voltage
Working Peak Reverse Voltage
DC Blocking Voltage
Average Rectified Forward Current
Total Device, (Rated VR), TC = 150°C
Peak Repetitive Forward Current
(Rated VR, Square Wave, 20 kHz), TC = 150°C
Non–repetitive Peak Surge Current
(Surge applied at rated load conditions halfwave, single phase, 60 Hz)
Operating Junction and Storage Temperature
THERMAL CHARACTERISTICS, PER LEG
Maximum Thermal Resistance, Junction to Case
Maximum Thermal Resistance, Junction to Ambient (1)
Temperature for Soldering
Purposes: 1/8″ from Case for 5 Seconds
(1) See Chapter 7 for mounting conditions
Total Device
Symbol
VRRM
VRWM
VR
IF(AV)
IFM
IFSM
TJ, Tstg
Value
600
8
16
16
100
– 65 to +175
R_θJC
2
R_θJA
50
TL
260
Unit
Volts
Amps
Amps
Amps
°C
°C/W
°C/W
°C
Designer’s Data for “Worst Case” Conditions — The Designer’s Data Sheet permits the design of most circuits entirely from the information presented. SOA Limit
curves — representing boundaries on device characteristics — are given to facilitate “worst case” design.
Designer’s and SWITCHMODE are trademarks of Motorola, Inc.
Thermal Clad is a trademark of the Bergquist Company
Preferred devices are Motorola recommended choices for future use and best overall value.
Rev 1
©^RM^eo^cto^trⁱo^fil^ea,^rIn^Dc^e. 1^v9^ic96^{e Data}
1