MOC8050 Datasheet, PDF (1/6 Pages) Motorola, Inc – 6-Pin DIP Optoisolators Darlington Ouput(No Base Connection)

MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
GlobalOptoisolator™
6-Pin DIP Optoisolators
Darlington Output
(No Base Connection)
The MOC8030 and MOC8050 devices consist of gallium arsenide infrared
emitting diodes optically coupled to monolithic silicon photodarlington detec-
tors. The chip to Pin 6 base connection has been eliminated to improve output
performance in high noise environments.
They are best suited for use in applications susceptible to high EMI levels.
• No Base Connection for Improved Noise Immunity
• High Collector–Emitter Breakdown Voltage — 80 Volts Minimum
• Higher Sensitivity to Low Input Drive Current
• To order devices that are tested and marked per VDE 0884 requirements, the
suffix ”V” must be included at end of part number. VDE 0884 is a test option.
Applications
• Appliances, Measuring Instruments
• I/O Interfaces for Computers
• Programmable Controllers
• Portable Electronics
• Interfacing and coupling systems of different potentials and impedance
• Solid State Relays
MAXIMUM RATINGS (TA = 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
INPUT LED
Reverse Voltage
Forward Current — Continuous
LED Power Dissipation @ TA = 25°C
with Negligible Power in Output Detector
Derate above 25°C
VR
3
Volts
IF
60
mA
PD
120
mW
1.41
mW/°C
OUTPUT DETECTOR
Collector–Emitter Voltage
Collector Current Continuous
VCEO
80
IC
150
Volts
mA
Emitter–Collector Voltage
Detector Power Dissipation @ TA = 25°C
with Negligible Power in Input LED
Derate above 25°C
VECO
PD
5
Volts
150
mW
1.76
mW/°C
TOTAL DEVICE
Isolation Surge Voltage(1)
(Peak ac Voltage, 60 Hz, 1 sec Duration)
VISO
7500
Vac(pk)
Total Device Power Dissipation @ TA = 25°C
Derate above 25°C
PD
250
mW
2.94
mW/°C
Ambient Operating Temperature Range(2)
Storage Temperature Range(2)
TA
– 55 to +100
°C
Tstg – 55 to +150
°C
Soldering Temperature (10 sec, 1/16″ from case)
TL
260
°C
1. Isolation surge voltage is an internal device dielectric breakdown rating.
1. For this test, Pins 1 and 2 are common, and Pins 4 and 5 are common.
2. Refer to Quality and Reliability Section in Opto Data Book for information on test conditions.
Preferred devices are Motorola recommended choices for future use and best overall value.
GlobalOptoisolator is a trademark of Motorola, Inc.
REV 2
©^MM^oot^to^or^ro^ola^l,^aIn^Oc.^p1^t9^o9^e5^{lectronics Device Data}
Order this document
by MOC8050/D
MOC8030
[CTR = 300% Min]
MOC8050
[CTR = 500% Min]
Motorola Preferred Devices
STYLE 3 PLASTIC
61
STANDARD THRU HOLE
CASE 730A–04
SCHEMATIC
1
6
2
5
3
4
PIN 1. LED ANODE
2. LED CATHODE
3. N.C.
4. EMITTER
5. COLLECTOR
6. N.C.
1