MC33102 Datasheet, PDF (1/14 Pages) ON Semiconductor – DUAL SLEEP-MODE OPERATIONAL AMPLIFIER

Order this document by MC33102/D
Sleep-Mode™ Two-State,
Micropower Operational
Amplifier
The MC33102 dual operational amplifier is an innovative design concept
employing Sleep–Mode technology. Sleep–Mode amplifiers have two
separate states, a sleepmode and an awakemode. In sleepmode, the
amplifier is active and waiting for an input signal. When a signal is applied
causing the amplifier to source or sink 160 µA (typically) to the load, it will
automatically switch to the awakemode which offers higher slew rate, gain
bandwidth, and drive capability.
• Two States: “Sleepmode” (Micropower) and “Awakemode”
(High Performance)
• Switches from Sleepmode to Awakemode in 4.0 µs when Output Current
Exceeds the Threshold Current (RL = 600 Ω)
• Independent Sleepmode Function for Each Op Amp
• Standard Pinouts – No Additional Pins or Components Required
• Sleepmode State – Can Be Used in the Low Current Idle State as a
Fully Functional Micropower Amplifier
• Automatic Return to Sleepmode when Output Current Drops Below
Threshold
• No Deadband/Crossover Distortion; as Low as 1.0 Hz in the Awakemode
• Drop–in Replacement for Many Other Dual Op Amps
• ESD Clamps on Inputs Increase Reliability without Affecting Device
Operation
Sleep–Mode is a trademark of Motorola, Inc.
TYPICAL SLEEPMODE/AWAKEMODE PERFORMANCE
Characteristic
Sleepmode Awakemode
(Typical)
(Typical)
Unit
Low Current Drain
45
750
µA
Low Input Offset Voltage
0.15
0.15
mV
High Output Current Capability
0.15
50
mA
Low T.C. of Input Offset Voltage
1.0
1.0
µV/°C
High Gain Bandwidth (@ 20 kHz)
0.33
4.6
MHz
High Slew Rate
0.16
1.7
V/µs
Low Noise (@ 1.0 kHz)
MAXIMUM RATINGS
28
9.0
nV/√Hz
Ratings
Symbol
Value
Unit
Supply Voltage (VCC to VEE)
Input Differential Voltage Range
Input Voltage Range
VS
VIDR
VIR
+ 36
V
(Note 1)
V
Output Short Circuit Duration (Note 2)
Maximum Junction Temperature
Storage Temperature
tSC
(Note 2)
sec
TJ
+150
°C
Tstg
– 65 to +150
Maximum Power Dissipation
PD
(Note 2)
mW
NOTES: 1. Either or both input voltages should not exceed VCC or VEE.
2. Power dissipation must be considered to ensure maximum junction temperature (TJ)
is not exceeded (refer to Figure 1).
MC33102
DUAL SLEEP–MODE
OPERATIONAL AMPLIFIER
SEMICONDUCTOR
TECHNICAL DATA
D SUFFIX
PLASTIC PACKAGE
CASE 751
(SO–8)
8
1
P SUFFIX
PLASTIC PACKAGE
CASE 626
8
1
PIN CONNECTIONS
Output 1 1
2
Inputs 1
1
3
VEE 4
8 VCC
7 Output 2
6
2
5
Inputs
2
(Dual, Top View)
ORDERING INFORMATION
Device
Operating
Temperature Range
Package
MC33102D
TA = – 40° to +85°C
MC33102P
SO–8
Plastic DIP
MOTOROLA ANALOG IC DEVICE DATA
© Motorola, Inc. 1996
Rev 0
1