|
MC145173 Datasheet, PDF (1/33 Pages) Motorola, Inc – Dual-Band PLL Frequency Synhesizer with ADC and Frequency Counter | |||
|
MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Order this document
by MC145173/D
Advance Information
Dual-Band PLL Frequency
Synthesizer with ADC and
Frequency Counter
CMOS
The MC145173 is a singleâchip CMOS synthesizer with a fourâwire serial
interface for primary use in AMâFM broadcast receivers. The device also finds
use in longâwave (LW) and shortâwave (SW) receivers. Two inputs to a single
highâspeed N counter are provided, along with 2 phase detectors; one for a
VHF loop up to 130 MHz, and another for an HF loop up to 40 MHz. The VHF
phase detector has a current source/sink output and both detectors feature
linear transfer functions (no dead zones). An external crystal ties across
onâchip circuitry which drives a completelyâprogrammable reference counter.
Thus, a broad range of tuning resolution is possible. The crystal oscillator is
buffered and fed to an openâdrain output which is active in the HF mode only.
Due to the patented BitGrabber⢠registers, address or steering bits are not
needed in the serial data stream for random access of the registers. The serial
port is byteâoriented to facilitate control via an MCU. Tuning across a band is
accomplished with a twoâbyte transfer to the N register.
The 6âbit analogâtoâdigital converter (ADC) has two input channels. The
converter is read via a oneâbyte transfer which includes an endâofâconversion
(EOC) bit.
A 22âstage frequency counter is provided and accepts two IF (intermediate
frequency) signals. Primary use for the frequency counter is for the seek or
scan function on broadcast radio receivers. A proper frequency count ensures
tuning of valid stations on their center frequencies. Reading the count is
accomplished with a threeâbyte serial transfer which includes a countâcom-
plete (CC) bit.
Four general purpose digital outputs are included. One of the outputs is
openâdrain; the others are totemâpole (pushâpull). Two general purpose digital
inputs are provided also. One input has a comparator with a switch point at 33%
of VDD.
⢠Operating Voltage Range: 4.5 to 5.5 V
⢠Maximum Operating Frequency: VHFin = 130 MHz @ 210 mV pâp
HFin = 40 MHz @ 210 mV pâp
⢠Maximum Frequency of Reference Counter: 15 MHz
⢠Maximum Frequency of Frequency Counter: 20 MHz
⢠Maximum Supply Current: Operating Mode = 12 mA
Standby Mode = 30 µA
⢠Approximate ADC Conversion Time: 360 µs
⢠Operating Temperature Range: â 40 to + 85°C
⢠R Counter Division Range: 1 and 5 to 16,383
⢠N Counter Division Range: 40 to 32,767
⢠Accommodates Downconversion or Upconversion Receiver Design
for AM Broadcast Band
⢠Direct Interface to Motorola SPI Data Port
⢠Programmerâs Guide Included in Datasheet
MC145173
24
1
DW SUFFIX
SOG PACKAGE
CASE 751E
ORDERING INFORMATION
MC145173DW SOG Package
PIN ASSIGNMENT
OSCin 1
ENB 2
Din 3
CLK 4
Dout 5
INPUT D 6
INPUT C 7
INPUT B 8
INPUT A 9
HF IFin 10
VHF IFin 11
OUTPUT A 12
24 OSCout
23 REFout
22 OUTPUT D
21 VHF PDout
20 Rx
19 VSS
18 HF PDout
17 VDD
16 HFin
15 VHFin
14 OUTPUT C
13 OUTPUT B
BitGrabber is a trademark of Motorola, Inc.
This document contains information on a new product. Specifications and information herein are subject to change without notice.
M© OMoTtoOroRla,OInLc.A1995
REV 1
3/95
MC145173
1
|
▷ |