MC10EP16 Datasheet, PDF (1/4 Pages) ON Semiconductor – Differential Receiver

MOTOROLA
SEMICONDUCTOR TECHNICAL DATA
Product Preview
Differential Receiver
The MC10EP16 is a differential receiver. The device is functionally
equivalent to the EL16 device with higher performance capabilities. With
output transition times significantly faster than the EL16 the EP16 is
ideally suited for interfacing with high frequency sources.
The EP16 provides a VBB output for either single-ended use or as a DC
bias for AC coupling to the device. The VBB pin should be used only as a
bias for the EP16 as its current sink/source capability is limited.
Whenever used, the VBB pin should be bypassed to ground via a 0.01µf
capacitor.
Under open input conditions (pulled to VEE) internal input clamps will
force the Q output LOW.
• 160ps Propagation Delay
• High Bandwidth Output Transitions
• 75kΩ Internal Input Pulldown Resistors
• >1000V ESD Protection
• Maximum Frequency > 2.7GHz
• VBB Sink/Source Current = 0.5mA maximum
• Component Count = 22 NPN devices
NOTE: Inputs have 75kΩ to VEE on D input and 75kΩ to VEE and VCC on D input
and when left open, force outputs to known state Q=Low, Q=High. Solder
temp 265°C for maximum for < 2–3 seconds; 245°C desired.
MC10EP16
D SUFFIX
8–LEAD PLASTIC SOIC PACKAGE
CASE 751-06
PIN DESCRIPTION
PIN
D, D
Q, Q
VBB
FUNCTION
Data Inputs
Data Outputs
Ref. Voltage Output
NC 1
D2
75k
75k
D3
75k
VBB 4
8 VCC
7Q
6Q
5 VEE
Figure 1. 8–Lead Pinout (Top View) and Logic Diagram
This document contains information on a product under development. Motorola reserves the right to change or
discontinue this product without notice.
3/98
© Motorola, Inc. 1998
1
REV 0