AM26LS31 Datasheet, PDF (1/4 Pages) Motorola, Inc – Quad Line Driver with NAND Enabled Three-State Outputs

Order this document by AM26LS31/D
Quad Line Driver with NAND
Enabled Three-State Outputs
AM26LS31
The Motorola AM26LS31 is a quad differential line driver intended for
digital data transmission over balanced lines. It meets all the requirements of
EIA–422 Standard and Federal Standard 1020.
The AM26LS31 provides an enable/disable function common to all four
drivers as opposed to the split enables on the MC3487 EIA–422 driver.
The high impedance output state is assured during power down.
• Full EIA–422 Standard Compliance
• Single + 5.0 V Supply
t • Meets Full VO = 6.0 V, VCC = 0 V, IO 100 µA Requirement
• Output Short Circuit Protection
• Complementary Outputs for Balanced Line Operation
• High Output Drive Capability
• Advanced LS Processing
• PNP Inputs for MOS Compatibility
QUAD EIA–422 LINE DRIVER
WITH THREE–STATE OUTPUTS
SEMICONDUCTOR
TECHNICAL DATA
D SUFFIX
PLASTIC PACKAGE
CASE 751B
(SO–16)
PC SUFFIX
PLASTIC PACKAGE
CASE 648
Representative Block Diagrams
Non–Inverting
Input
Outputs
Enable
Output
Controls
Enable
Inverting
Input
H
L
X
TRUTH TABLE
Control
lnputs
(E/E)
Non–Inverting Inverting
Output
Output
H/L
H
L
H/L
L
H
L/H
Z
Z
L = Low Logic State
H = High Logic State
X = Irrelevant
Z = Third–State (High Impedance)
* Note that the surface mount MC26LS31D device uses the same die as in the plastic DIP
* AM26LS31DC device, but with an MC prefix to prevent confusion with the package suffix.
MOTOROLA ANALOG IC DEVICE DATA
PIN CONNECTIONS
Input A 1
2
Outputs A
3
Enable ⁴
5
Outputs B
6
Input B 7
Gnd ⁸
16 VCC
15 _{Input D}
14
Outputs D
13
12 _Enable
11
Outputs C
10
9 Input C
ORDERING INFORMATION
Device
Operating
Temperature Range Package
AM26LS31PC
MC26LS31D*
TA = 0 to +70°C
Plastic DIP
SO–16
© Motorola, Inc. 1995
1