URC240312D-30WR2 Datasheet, PDF (5/6 Pages) MORNSUN Science& Technology Ltd. – REGULATED THREE OUTPUT DIP DC-DC CONVERTER

HEATSINK ASSEMBLY & PACKAGE DIAGRAM
TEST CONFIGURATIONS
Input Reflected-Ripple Current Test Setup
Input reflected-ripple current is measured with an inductor Lin and Cin to simulate source impedance.
Oscilloscope
Lin
DC DC ^Current
Cin Probe
Load
Lin(4.7µH) Cin(220µF, ESR < 1.0Ω at 100 KHz)
DESIGN CONSIDERATIONS
1) Recommended circuit
All the URC_D-30WR2 Series have been tested according to the following recommended test circuit before leaving the factory (see Figure 4).
If you want to further decrease the input/output ripple, you can increase a capacitance-values properly or choose capacitors with low ESR, but the
total capacitance of the filter capacitor must not exceed the Max. Capacitive Load.
Recommend external capacitor see table 1.
Vin
GND
C in
Vo 1
Vo 2
Cout
Cout
DC DC
Cout
0V
-Vo 2
(Figure 4)
Vout（VDC）
3.3/5
±12/±15
(Table 1)
Cin（uF）
10uF
10uF
Cout（uF)
10uF
4.7uF
2) It is not recommended to increase the output power capability by connecting two or more converters in parallel. The product is not
hot-swappable
The copyright and authority for the interpretation of the products are reserved by MORNSUN
URC_D-30WR2 2013.03.11-A/0 Page 5 of 6