QA01 Datasheet, PDF (5/5 Pages) MORNSUN Science& Technology Ltd. – Application Design For IGBT Driver DC-DC Converter

Note:
1. The wire between the converter and IGBT driver should be as short as possible.
2. External filter capacitors should be placed as close as possible to the converter and the IGBT driver.
3. The average power of the IGBT driver should be less than the output power of DC-DC module.
4. For the application of shocking, recommend to glue the module by glue.
5. Max. Capacitive Load is tested at nominal input voltage and full load.
6. Unless otherwise noted, All specifications are measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load.
7. In this datasheet, all test methods are based on our corporate standards.
8. All characteristics are for listed models, and non-standard models may perform differently. Please contact our technical support for more detail.
9. Please contact our technical support for any specific requirement.
10. Specifications of this product are subject to changes without prior notice.
MORNSUN Science & Technology Co.,Ltd.
Address: No. 5, Kehui St. 1, Kehui development center, Science Ave., Guangzhou Science City, Luogang district, Guangzhou,P.R.China.
Tel: [phone]
Fax:[phone]
E-mail: [e-mail]
Http://www.mornsun-power.com
The copyright and authority for the interpretation of the products are reserved by MORNSUN
QA series
2013.11.21-A/4 Page 5 of 5