F0305D-1W Datasheet, PDF (3/3 Pages) MORNSUN Science& Technology Ltd. – DUAL/SINGLE OUTPUT DC-DC CONVERTER

OUTLINE DIMENSIONS & PIN CONNECTIONS
MECHANICAL DIMENSIONS
20.00 [0.787]
10.00 [0.394]
(Side View)
7.00 [0.276]
0.50 [0.020]
4.10 [0.161]
17.78 [0.700]
15.24 [0.600]
7.62 [0.300]
1
7
(Bottom View)
14
10 9 8
0.30 [0.012]
∅1.00 [∅0.039]
0.50 [0.020]
2.54 [0.100]
Note:
Unit:mm[inch]
Pin section tolerances: 0.10mm[ 0.004inch]
General tolerances: 0.25mm[ 0.010inch]
FOOTPRINT DETAILS
Pin Single Dual
1
GND GND
7
NC
NC
8
+Vo
+Vo
9 No Pin 0V
10
0V
-Vo
14
Vin
Vin
NC: No connection
RECOMMENDED FOOTPRINT
DUAL OUTPUT
14
10 9 8
1
7
∅1.00 [∅0.039]
2.54 [0.100]
SINGLE OUTPUT
2.54 [0.100]
14
10
8
1
7
TUBE OUTLINE DIMENSIONS
12.00 [0.472]
8.60 [0.339]
14.70 [0.579]
0.60 [0.024]
5.30 [0.209]
Note:
Unit :mm[inch]
General tolerances: 0.50mm[ 0.020inch]
L=530mm[20.866inch] Tube Quantity: 25pcs
L=220mm[8.661inch] Tube Quantity: 10pcs
Note:
1. Operation under minimum load will not damage the converter; However, they may not meet all specification listed.
2. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
3. In this datasheet, all the test methods of indications are based on corporate standards.
4. Only typical models listed, other models may be different, please contact our technical person for more details.
The copyright and authority for the interpretation of the products are reserved by Mornsun
Specifications subject to change without notice.
E_D-1W & F_D-1W A/2-2009 Page 3 of 3