B0515YS-1W Datasheet, PDF (3/3 Pages) MORNSUN Science& Technology Ltd. – SINGLE OUTPUT DC-DC CONVERTER

OUTLINE DIMENSIONS & FOOTPRINT DETAILS
MECHANICAL DIMENSIONS
(Fron t View) 10.00 [0.394]
RECOMMENDED FOOTPRINT
∅1.00 [0.039]
1 2 34
0.50 [0.020]
7.62[0.300]
4.10 [0.161]
0.30[0.012]
11.60[0.457]
(Bo tto m Vie w)
1 234
0.50[0.020]
6.00[0.236]
0.90 [0.035]
Note:grid 2.54*2.54mm .
TUBE OUTLINE DIMENSIONS
9.60[0.378]
FOOTPRINT DETAIL S
Pin
Function
1
Vin
2
GND
3
0V
4
+Vo
N ote:
U nit:mm[inch]
Pin section tolerances: ±0.10mm[±0.004inch]
General tolerances:±0.25mm[±0.010inch]
Note:
Unit :mm[inch]
4.90[0.193]
General tolerances: ±0.50mm [±0.020inch]
L=530mm[20.866inch] pcs/tube: 43
L=220mm[8.661inch] pcs/tube: 17
Short tube inner package dimensions: L*W*H= 255*170*80mm
Short tube outer package dimensions(with six inner package boxes):
L*W*H= 375*280*270mm
Long tube inner package dimensions: L*W*H= 580*200*100mm
Long tube outer package dimensions(with two inner package boxes):
L*W*H= 600*215*220mm
Long tube outer package dimensions(with three inner package boxes):
L*W*H= 600*215*325mm
Note:
1. Operation under minimum load will not damage the converter; However, they may not meet all specification listed.
2. All specifications measured at Ta=25°C, humidity<75%, nominal input voltage and rated output load unless otherwise specified.
3. Only typical models listed, other models may be different, please contact our technical person for more details.
4. In this datasheet, all the test methods of indications are based on corporate standards.
The copyright and authority for the interpretation of the products are reserved by MORNSUN
Specifications subject to change without notice.
B_YS-1W
A/4-2012
Page 3 of 3