English
Language : 

B0305M-1W Datasheet, PDF (3/4 Pages) MORNSUN Science& Technology Ltd. – ISOLATED & UNREGULATED SINGLE OUTPUT DC-DC CONVERTER
Efficiency VS Input Voltage curve
(Full Load)
B0505M-1W
100
90
80
70
60
50
40
30
20
10
0
Input Voltage(V)
Efficiency VS Output Load curve
(Vin=Vin-nominal)
B0505M-1W
100
90
80
70
60
50
40
30
20
10
0
10 20 30 40 50 60 70 80 90 100
Total Output Current (% )
OUTLINE DIMENSIONS, RECOMMENDED FOOTPRINT & PACKAGING
MECHANICAL DIMENSIONS
RECOMMENDED FOOTPRINT
(Front View)
0.50[0.020]
11.50[0.453]
7.62
[0.300]
1234
(Bottom View)
1 2 34
∅1.00[0.039]
Note:grid 2.54*2.54mm.
TUBE OUTLINE DIMENSIONS
9.60
[0.378]
FOOTPRINT DETAILS
Pin Function
1
GND
2
Vin
3
0V
4
+Vo
Note:
Unit:mm[inch]
Pin section tolerances:±0.10mm[±0.004inch]
General tolerances:±0.25mm[±0.010inch]
Note:
4.90 [0.193]
Unit :mm[inch]
General tolerances: ± 0.50mm[ ±0.020inch]
L=530mm[20.866inch] Tube Quantity: 43pcs
L=220mm[8.661inch] Tube Quantity: 17pcs
Short tube inner package dimensions: L*W*H= 255*170*80mm
Short tube outer package dimensions(with six inner package boxes):
L*W*H= 375*280*270mm
Long tube inner package dimensions: L*W*H= 580*200*100mm
Long tube outer package dimensions(with two inner package boxes):
L*W*H= 600*215*220mm
Long tube outer package dimensions(with three inner package boxes):
L*W*H= 600*215*325mm
TEST CONFIGURATIONS
Input Reflected-Ripple Current Test Setup
Input reflected-ripple current is measured with an inductor Lin and Capacitor Cin to simulate source impedance.
Oscilloscope
Lin
DC DC Current
Cin Probe
Load
Lin(4.7µH) Cin(220µF, ESR < 1.0Ω at 100 KHz)
DESIGN CONSIDERATIONS
1) Requirement on output load
To ensure this module can operate efficiently and reliably, During operation, the minimum output load could not be less than 10% of the full load. If
the actual output power is very small, please connect a resistor with proper resistance at the output end in parallel to increase the load, or use our
company’s products with a lower rated output power (B_M-W2 series).
The copyright and authority for the interpretation of the products are reserved by MORNSUN
B_M-1W B/1-2012
Page 3 of 4