URA2405D-5W Datasheet, PDF (2/2 Pages) MORNSUN Science& Technology Ltd. – DUAL/SINGLE OUTPUT DC-DC CONVERTER

OUTPUT SPECIFICATIONS
Item
Test Conditions
Min Typ Max Units
Output Power
See above products program
Positive Voltage Accuracy Refer to recommended circuit
Negative Voltage Accuracy Refer to recommended circuit
Load Regulation
From 10% To 100% load
Line Regulation(at full load) Input voltage from low to high
Temperature Drift(Vout)
Refer to recommended circuit
5
W
±1
±3
±3
±5
%
±0.5 ±1*
±0.2 ±0.5
0.02
%/°C
Ripple**
Noise**
20MHz bandwidth
20MHz bandwidth
30 50
mVp-p
75 150
Switching Frequency
100% load, nominal Input voltage
300
KHz
*Dual output models unbalanced load: ±5%.
**Test ripple and noise by “parallel cable” method. See detailed operation instructions at Testing of
Power Converter section, application notes.
Note:
1.All specifications measured at TA=25°C, humidity<75%, nominal input voltage and rated output load unless
otherwise specified.
2. See below recommended circuits for more details.
TYPICAL CHARECTERISTICS
Temperature Derating Graph
APPLICATION NOTE
Recommended Circuit
All the URA_D-5W & URB_D-5W Series have
been tested according to the following
recommended testing circuit before leaving
factory. This series should be tested under load.
Never be tested under no load (see Figure 1).
Dual Output
Vin
Cin
GND
Single Output
Vin
Cin
GND
DC DC
DC DC
(Figure 1)
+Vout
0V
-Vout
+Vout
0V
If you want to further decrease the output ripple,
you can increase capacitance properly or choose
capacitors with low ESR. However, the
capacitance should not be too high. (Table 1).
External Capacitor Table(Table 1)
Vin
(VDC)
Cin
(uF)
Vout
(VDC)
Cout
12
100
5
24
100
12
100uF/
1A
48
100
15
--
--
24
Operating Temp.( C )
OUTLINE DIMENSIONS & FOOTPRINT DETAILS
27.50(1.083)
10.16 10.16
(0.400) (0.400)
3
Bottom View
First Angle Projection
RECOMMENDED FOOTPRINT
Top view,grid:2.54mm(0.1inch),
diameter:1.00mm(0.039inch)
Dual Output
Single Output
5.08
(0.200)
Side View
Note:
Unit:mm(inch)
Pin diameter:0.80mm(0.031inch)
Pin diameter tolerances: 0.05mm( 0.002inch)
General tolerances: 0.25mm( 0.010inch)
FOOTPRINT DETAILS
Pin Single
Dual
1
GND
GND
2
Vin
Vin
3
+Vo
+Vo
4
No Pin
0V
5
0V
-Vo
MORNSUN reserves the copyright
Specifications subject to change without notice.
URA_D-5W & URA_D-5W A/3-2008
Page 2 of 2