TS107L-F-2 Datasheet, PDF (1/4 Pages) MORNSUN Science& Technology Ltd. – VOLTAGE SIGNAL INPUT & CURRENT SIGNAL OUTPUT

TWO-WIRE LOOP-POWERED
SIGNAL CONDITIONING MODULES
VOLTAGE SIGNAL INPUT & CURRENT SIGNAL
OUTPUT
——TxxxxL-F
FEATURES
l Output loop-powered
l High accuracy (0.1% F.S.)
l High linearity (0.1% F.S.)
l High isolation voltage(2KVAC/1mA)
l Small size: SIP9 (26*9.5*12.5mm)
l Extremely low temperature drift:50PPM/℃
l Operating temperature range: -40°C ~
+85°C
l ESD protection(±4KV)
PART NUMBER SYSTEM
TxxxxL-F
Loop-powered series
Package
Isolation power output
Power supply
Signal output
Signal input
Product series
GENERAL DESCRIPTION
TxxxxL-F is a voltage input and two-wire current output
loop-powered signal conditioning module.After the adoption of
the current loop feed-level approach to the pre-power devices
and equipment received from the preceding stage output
voltage signal.The isolation module output 4 ~ 20mA standard
two-wire current signal.
This product incorporates a unique electromagnetic
isolation mode and high performance level after feeding
technology, the voltage signal to a 4 ~ 20mA standard signal
isolation accurate conversion, can be used with a variety of
instruments analog input port (such as PLC, DCS systems,
etc.) to match.
In addition, this module has extremely small form factor
(SIP9) and excellent temperature drift characteristics (at -40
℃ ~ +85 ℃ operating temperature range drift is less than
50PPM / ℃), the input and output ends of energy bear 2KVAC
isolation voltage.
SELECTION GUIDE
Model
Loop Supply Voltage
TS107L-F-2
10~24VDC
Distribution Voltage
3.3V
Input Signal
0~2V
Output Signal
4~20mA
Channels
1
Package
SIP9
Input signal
Distribution
ELECTRICAL SPECIFICATIONS
Input signal
See selection guide
Input impedance
≥10MΩ
Over-load
≤5V
Distribution voltage
See selection guide
Distribution voltage accuracy
±3%
Maximum load current
≥3mA
Short circuit protection
Sustainable distribution circuit; withdrawal product to resume normal work after a
fault
Output Signal
The Min. supply voltage
See selection guide
10V(Signal output load)
The Max. supply voltage
30V；(Need to consider power consumption, long-term work in the 30V power
supply, no-load status may overheat and damage the module)
Output signal
The power port equivalent capacitance
Load ability
Load regulation
Ripple & Noise
≤2.2μF*1.05
RL≤（Vin–10）/0.02 Ω
Us：Loop supply voltage
≤0.05%F.S./100Ω
≤30mVpp(20MHz bandwidth,250Ω/0.01μF load)
The copyright and authority for the interpretation of the products are reserved by MORNSUN
TxxxxL-F 2013.12.11-A/0
Page 1 of 4