TRP16130P Datasheet, PDF (1/4 Pages) MORNSUN Science& Technology Ltd. – Isolated Module

Isolated Module
TRP16130P
RTDs detection type isolated module
FEATURES
l Two-wire, three-wire or four- wire Pt100/Cu50/Cu100
RTDs signal input
l High precision grade (0.2% F.S.)
l High linearity (0.2% F.S.)
l Isolation voltage (2.0KVAC/60s)
l Low ripple & noise: ≤30mVp-p
l Extremely low temperature drift (50PPM/℃,
within -40 to +85℃.Typ.)
l Industrial grade (range of operating
temperature: -40 to +85℃)
l Auxiliary power: 5V/12V/15V /24V DC single
power supply
l Industry standard signal output :
4~20mA/0~5V/0~10V etc.
l Low cost, Ultra-small size, Convenient to use,
High reliability
l Standard DIP24(31.8*20.3*9.5mm), Meets
UL94V-0 flame retardant package
TRP / C Series temperature signal isolation module is a hybrid integrated circuit, it is the RTD signal by the level of isolation of temperature
converted into a standard linear with temperature signal. The circuit on the same chip integrates a set of multi-channel high isolated DC /
DC power supply, Several high-performance signal isolators, and RTD linearization, long-term compensation, interference suppression
circuit. Especially suitable for Pt100/Cu50/Cu100 RTD signal isolation converted into a standard signal isolation, Temperature signals
transmission and remote without distortion, Temperature signal acquisition and isolated of DCS system or industrial site PLC.
Chip integrates a high-efficiency DC-DC, it can produce two groups were separated from each other to the internal power amplifier
inputs, modulation circuit supply and Outputs of the demodulator circuit, Switching circuit, and filter circuit. SMD technology structure and
new isolation technologies allow the device to achieve: power, signal input and signal output 2000VAC Three-terminal isolation. The
product can meet the harsh operating environment requirements. Such as industrial grade temperature, humidity and vibration
environment.
TRP / C Series temperature signal isolation module very convenient to use, with minimal external components to achieve Pt100/Cu50/
Cu100 RTD signal isolation transmitter. It can also achieve industrial site temperature control signal of 1 input 2 output and 1 input 4 output
functions.
Selection Guide
Part No.
Power Supply input (VDC)
TRP16130P
24
Notes: Customization products are available if required.
Input Signal
Pt100 （0~200℃）
Output Signal
4-20mA
Isolation Power
Output (VDC)
None
Input Specifications
Item
Input Power
Supply
Input voltage
Input power
Power supply protection
Input
Input signal
Input impedance
Operating Conditions
Signal, power full load
Value
24V ±5%
≤1W
Reverse polarity protection
Pt100
0~200℃
Output Specifications
Item
Output signal
Output
Load capacity
Load regulation
Ripple & noise
Operating Conditions
Voltage output
Current output @ 20mA
Bandwidth 20MHz
Value
4~20mA
≥10KΩ
≤500Ω
0.050%
≤30mVpp
2014.04.11-A/0
Page 1 of 4
MORNSUN Guangzhou Science & Technology Co., Ltd. reserves the copyright and right of final interpretation