76650-0053 Datasheet, PDF (1/3 Pages) MolexKits – Insulated Ring, Spade, Butt Splice, Closed-End Solderless Terminal

1801 Morgan Street
Rockford, Illinois 61102
800-435-2931
www.molexkits.com
Datasheet for 76650-0053
General Information
Part Number:
76650-0053
Manufacturer:
Molex / Waldom
Title:
Description:
Deluxe Solderless Term Kit
Insulated Ring, Spade, Butt Splice, Closed-End Solderless Terminal .187" and .250 "
Fully Insulated Female Quick Disconnect with Universal Crimp tool
Product Family: Terminals
Certificates:
(Molex Parts within this kit) - EU RoHS Compliant
Country of Origin: Kit assembled in U.S.A.
Specifications
Design
Configuration:
Connector Type:
Tab Sizes:
Stud Sizes:
Insulation:
Wire size:
(Wire-to-Wire) and (Wire-to-Board) / Solderless Terminals
Solderless Terminals
.187" and .250"
5-6 (M3-3.5)
Nylon and PVC
(22-18), (16-14) and (12-10) AWG
Product Highlights
Quick disconnects allow for quickly connecting or disconnecting a terminal. The front
end of the terminal has a female-type receptacle which allows the terminal to slide
onto and off of a male blade. Flags are a type of product that are used when there is
a space constraint, and a regular straight Quick Disconnect is too large.
Piggyback Quick Disconnects can be used when multiple connections (also called
piggyback) are required and there are a limited number of male tabs. The piggyback
actually allows another QD to be connected to its tab and then the piggyback is
connected to a tab.
Spades have the open tongue end used for rapid insertion on the mounting screw.
The spade is usually used on free standing studs.
The Snap plug is a round bullet-like terminal that plugs or "snaps" into the female
receptacle. Snaps are used in a variety of applications where a "quick disconnect"
connection is needed, but there is not enough space for a normal QD coupler. Like a
coupler set, the male and female pieces can be connected and disconnected many
times.
Closed-end connectors are used in a variety of situations to "pigtail" or tie together
2 or more wires.
Butt Splices allow two stripped wires to be inserted into each end and "butt" in the
center, with the crimp securing both wires together.
The Step Down Butt Splice is the perfect solution when 2 wires need to be
inserted in one end of a splice and a single wire in the other end.
For additional Molex / Waldom Design and Solution kits please go to www.molexkits.com
Page 1 of 3