0638160700 Datasheet, PDF (9/17 Pages) Molex Electronics Ltd. – AIR POWERED TOOL AIR POWERED TOOL

Air Powered Tool
3.1 Set-Up
1. Read the following instructions before attempting to operate this tool.
2. Connect an 8mm or 5/16” air hose to the fitting attached to the rear of the tool and to air supply 6 to 6.5 bar (87
to 94 psi). Do not exceed 8 bar (116 psi). May cause injury or damage to the tool. Air supply must be
equipped with an air filter regulator (not supplied by Molex). (Available from any industrial supply co.). See
Figure 3-1.
TRIGGER
SAFETY
TRIGGER
TO AIR
SUPPLY
MODULE CRIMP
HEAD (REF)
AIR HOSE
Figure 3-1
FILTER REGULATOR
LUBRICATOR
(NOT SUPPLIED)
If changing to the Optional bench adapter, remove the air hose and connect the tubing from the footswitch. See
Figure 3-2.
CONNECT TUBING FROM
FOOT SWITCH
SECURE AIR
CRIMPING TOOL
WITH FITTING
TO AIR
SUPPLY
IN POSITION
MODULE CRIMP
HEAD
(Reference)
BENCH
ADAPTER
(OPTIONAL)
(NOT SUPPLIED)
FOOT SWITCH
(OPTIONAL)
FILTER REGULATOR
LUBRICATOR
(NOT SUPPLIED)
Figure 3-2
Order No: TM-638160100 Release Date: 02-20-08
Revision: B
Revision Date: 05-28-10
UNCONTROLLED COPY
Page 9 of 17