0460152406 Datasheet, PDF (7/13 Pages) Molex Electronics Ltd. – PRODUCT SPECIFICATION FOR Mini-Fit Plus HCS™

PRODUCT SPECIFICATION
6.0 PRODUCT PERFORMANCE TESTS & REQUIREMENTS
6.1 ELECTRICAL REQUIREMENTS
ITEM
TEST
TEST PROCEDURE
1
Contact
Resistance
(Low Level)
EIA-364-23: Mate connectors; apply a
maximum voltage of 20 mV and a current
of 100 mA. Wire resistance shall be
removed from the measured value.
2
Insulation
Resistance
Mate connectors: apply a voltage of 500
VDC between adjacent terminals and
between terminals to ground.
3
Dielectric
Withstanding
Voltage
EIA-364-20: Apply a voltage of 1500 VAC
for 1 minute between adjacent contacts.
EIA-364-70 (Temperature Rise) & EIA-364-
55 (Current Cycling): Apply current to
mated connectors & incrementally increase
4
Temperature Rise until specified T-Rise is reached to
(via Current Cycling) establish rated current. Measure the T-Rise
at the rated current after 96 hours, during
current cycling (45 minutes ON and 15
minutes OFF per hour) for 240 hours, and
after final 96-hour steady state.
REQUIREMENT
10 mΩ Maximum Initial
resistance for each test
sequence. Resistance
measurements for subsequent
tests are the Maximum change
from Initial as specified.
1000 Megohms
MINIMUM
No breakdown.
Current leakage < 5 mA
Temperature rise:
+30°C MAXIMUM
6.2 MECHANICAL REQUIREMENTS
ITEM
TEST
TEST PROCEDURE
REQUIREMENT
Tin, W-W & W-B (formed pin):
Mate: 15.6 N (3.50 lbf) MAX.
Terminal Mate /
Unmate: 13.8N (3.10 lbf) MAX.
Unmate Forces
Per Circuit for:
Mate and unmate female to male crimp
Gold, W-W & W-B (formed pin):
terminal or female terminal to header at a
Mate: 4.9 N (1.10 lbf) MAX.
1
Wire – Wire;
Wire – Board
(formed pin header);
and
Wire – Board (solid
rate of 25 ± 6 mm (1 ± ¼ inch) per minute.
Testing to be conducted with individual
(single) circuit. Measure and record the
maximum mate and unmate forces across 5
mating cycles.
Unmate: 4.0 N (0.91 lbf) MAX.
Tin, W-B (solid pin):
Mate: 10.5 N (2.36 lbf) MAX.
Unmate: 11.0N (2.47 lbf) MAX.
pin header)
Gold, W-B (solid pin):
Mate: 3.4 N (0.77 lbf) MAX.
Unmate: 2.8 N (0.63 lbf) MAX.
REVISION:
C1
ECR/ECN INFORMATION: TITLE:
EC No: UCP2011-0141
DATE: 2010 /07/15
PRODUCT SPECIFICATION FOR
MINI-FIT PLUS HCS
CONNECTOR SYSTEM
SHEET No.
7 of 13
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
PS-45750-001
BWIRKUS
BWIRKUS
APATEL
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC