0638191000 Datasheet, PDF (5/8 Pages) Molex Electronics Ltd. – Application Tooling Specification Sheet

Hand Crimp Tool For Mini-Fit™ Jr. Crimp Terminals
3.
4. Lift and pull away from the hand tool. The top locator hooks should slip out of the top slots easily. See Figure
7A.
5. To reinstall the new locator, make sure the
hand tool is in the open position.
LOCATOR
6. Press the red insert down as far as it will go
as shown in Figure 7B.
7. Holding onto the lower part of the locator
SQUEEZE
HERE
MAKE SURE
with your thumb and index finger, insert the
locators top hooks (2) into the hand tool top
slots.
8. Rotate the locator down and press the
lower tabs into the two bottom slots of the
SQUEEZE
HERE
Figure 7A
TOP SLOTS OF
HANDTOOL
CENTER OF LOCATOR
IS IN THE
DOWN POSITION
hand tool. To secure the locator into place,
the lower tabs must snap into place on the
TOP HOOKS
hand tool frame.
Right or Left Hand Operation
This hand tool has an added feature that can
be converted from a right handed application to
a left handed application. It is necessary to
reverse the tooling if using the left handed
application along with the locator. Follow the steps below:
LOWER TABS
Figure 7B
JAWS OPEN
PULL OPEN
TOOLING
M3 BHCS
TOOLING
MATCH
UP MARKS
Figure 9
Figure 8
PUSH ON
HANDLE
FRONT
BACK
1. The locator must be removed before reversing the tooling.
2. Remove the M3 BHCS which is holding the upper tooling.
3. Flip the upper tooling to the opposite side and replace the M3 BHCS. Make sure the small markings on the
front and back of the hand tool frame, match up and are on the outside of the hand tool frame. See Figure 8
and 9.
4. Do the same thing with the lower tooling and tighten the M3 screws. Be sure the small markings line up.
5. Reinstall the locator by following the Instructions in the locator replacement section.
Doc No: ATS-638191000 Release Date: 12-07-07
Revision: B
Revision Date: 10-14-10
UNCONTROLLED COPY
Page 5 of 8