0621009610 Datasheet, PDF (10/27 Pages) Molex Electronics Ltd. – I-TRAC™ BACKPLANE and DAUGHTERCARD INSTALLATION and REPAIR TOOLING Operation Manual

I-Trac™ Backplane and Daughtercard Tooling
5. If using the support fixture and an appropriate press, seat
the DaughterCard module until there is less than 0.10mm
(.004 in) clearance between the bottom of the plastic
housing and the surface of the printed circuit board.
6. Remove the loaded support pallet from the press.
7. Remove the insertion tool.
8. Carefully remove the assembled printed circuit board
from the support pallet.
Vertical Power Module Press-In Tooling
PRESS-IN
TOOL
CONNECTOR
ASSEMBLY
PC BOARD
LOCATING
PIN
Figure 2-10
SUPPORT PALLET
CAUTION: Vertical Power Module must be installed separately without any Backplane or DaughterCard
assemblies in the combinations.
WITH 62201-95XX
HOLDER
PRESS-IN
TOOL
GUIDE SUFACES
ALONE
POWER
MODULE
Figure 2-11
PRESS-IN
TOOL
GUIDE SUFACES
POWER
MODULE
M3 SET
SCREW
TOOLING
HOLDER
VERTICAL
PRESS-IN
TOOL
VERTICAL
POWER
MODULE
PC BOARD
Figure 2-12
Depending on the number of modules to be installed and/or the press used, this tool can be used as a stand-
alone or with a group of press-in tools, mounted in a 62201-95XX holder (ordered separately). See Figure 2-11.
1. If the tooling holder is being used, slide the insertion modules into the tooling holder in the proper order. The
modules are keyed so that they cannot be put in backwards.
2. Now tighten the M3 set screws against the modules using the following setups:
One (1) set screw against modules under 10mm wide
Two (2) set screws evenly spaced on a 10mm wide power module.
At least three (3) set screws evenly spaced on a 25mm wide power module.
3. Carefully pre-seat, by hand, the vertical power module(s) into the printed circuit board hole pattern. See
Figure 2-12. Make sure the module(s) are oriented properly to the printed circuit board layout.
4. Line-up the Press-In tool so that the guide surfaces on the tool are in line with the sides of the vertical power
module. See Figure 2-11.
Doc. No: TM-622018699
Revision: D
Release Date: 12-05-07
Revision Date: 04-15-10
UNCONTROLLED COPY
Page 10 of 27