0638235475 Datasheet, PDF (1/6 Pages) Molex Electronics Ltd. – Application Tooling Specification Sheet

Hand Crimp Tool for Wire-to-Wire and Wire-to-Board Terminals
Modular Crimp Head
Order No. 63823-5470
Application Tooling
Specification Sheet
TYPE 4A
Hand Crimp Tool
Order No. 63823-5400
FEATURES
% A full cycle ratcheting hand tool ensures complete crimps
% Ergonomically designed soft handles
% Precisely designed crimping profiles with simple contact positioning
% Easy handling due to outstanding force ratio
% Modular Crimp Head is removable and can be use in the Air Powered Tool Order No.63816-0100,
accompanied by Air Powered Crimp Adapter (Order No. 63816-0700).
% Can also be used in the Battery Powered Tool Order No.63816-0200 (110 V) or 63813-0250 (220 V),
accompanied by Battery Powered Crimp Adapter (Order No. 63816-0600).
SCOPE
Products: 3.96mm (.156”) Pitch Wire-to-Wire and 6.50mm (.256”) Pitch Wire-to-Board Crimp Terminals,
20, 24, and 26 AWG.
Terminal
Series
50598
50600
Terminal Order No. Wire Size
Insulation Diameter Wire Strip Length
Reel Form only AWG mm²
mm
In.
mm
In.
20 0.50 1.50-1.90 .059-.075
50598-8100
24 0.20 2.20-2.35 .087-.093
26
20
0.12 2.10-2.20
0.50 1.50-1.90
.083-.087
.059-.075
2.70-3.30 .106-.130
50600-8100
24 0.20 2.20-2.35 .087-.093
26 0.12 2.10-2.20 .083-.087
Customer to cut off terminal from reel: 0.25mm (.010”) maximum Cut-off Tab.
See crimp specification for the individual Insulation Diameter.
DEFINITION OF TERMS
BRUSH
INSULATION
CRIMP
▲SEE NOTE
BELL MOUTH
SEAM
BEND UP
ROLLING
STRIP
LENGTH
BEND
DOWN
TWISTING
CUT-OFF TAB
CONDUCTOR
CRIMP COND.CRIMP
HEIGHT
This illustration is a generic terminal representation and not an exact image of any terminal listed in the scope.
Doc No: ATS-6382354HM Release Date: 06-23-10
Revision: B
Revision Date: 10-13-10
UNCONTROLLED COPY
Page 1 of 6