0638111170 Datasheet, PDF (1/5 Pages) Molex Electronics Ltd. – Modular Crimp Head Specification Sheet

Modular Crimp Head for HCS-125 Pin and Socket Crimp Terminal
Modular Crimp Head
Specification Sheet
Order No. 63811-1170
FEATURES
Quick change Modular Crimp Head is easily installed into Power Crimp Adapter
Crimp head is interchangeable with the Air or Battery Power Actuators
Also installed into Hand Crimp Frames without the adapters
A precision user-friendly terminal locator wire stop holds terminals in the proper crimping position
Air or battery powered crimp tools help reduce fatigue and discomfort from repetitive manual crimping
SCOPE
Products: 3.18mm (.125") Diameter HCS-125 Pin and Socket Crimp Terminals, 10-14 AWG.
Terminal
Series No.
1900
1901
42546
42547
Terminal Order No.
Wire Size
Insulation Diameter
Strip Length
Loose Piece ●Reel
AWG mm²
mm
In.
mm
In.
18-12-2602 18-12-2601 10-14 5.25-2.00 3.56-4.57 .140-.180 4.06-5.59 .160-.220
18-12-1602 18-12-1601 10-14 5.25-2.00 3.56-4.57 .140-.180 4.06-5.59 .160-.220
18-12-1607 10-14 5.25-2.00 3.56-4.57 .140-.180 4.06-5.59 .160-.220
18-12-1604 18-12-1603 10-14 5.25-2.00 3.56-4.57 .140-.180 4.06-5.59 .160-.220
● Follow the Cut-Off Tab specifications on Applicator specification sheets.
These Terminals cannot be removed from the reel by manual cutting.
An applicator must be used or the terminals will not function properly.
DEFINITION OF TERMS
BRUSH
BELL MOUTH
INSULATION
CRIMP
SEAM
BEND UP
ROLLING
TWISTING
C/L
TERMINAL
LOCATION
CUT-OFF
TAB
STRIP
LENGTH
BEND
DOWN
CONDUCTOR
CRIMP
CRI
C/L
CRIMP
Terminal is to be centrally located between the two (2) cut-off tab edges by one half of the total cut-off tab
tolerance.
This illustration is a generic terminal representation and not an exact image of any terminal listed in the scope.
Doc No: ATS-638111170
Revision: A
Release Date: 03-25-10
Revision Date: 03-25-10
UNCONTROLLED COPY
Page 1 of 5