0621000100 Datasheet, PDF (1/4 Pages) Molex Electronics Ltd. – LFH™ FERRULE CRIMP HAND TOOL Operating Instruction and Specification Sheet

LFH™ Ferrule Crimp Hand Tool
LFH™ FERRULE CRIMP HAND TOOL
Operating Instruction and
Specification Sheet
Order No. 62100-0100
FEATURES
Ratchet with safety release that ensures consistent performance
Small handle spread which make this style tool ideally suited for end users
SCOPE
Products: LFH™ 60 Circuit Crimp Ferrule
Ferrule
Cable Outer Diameter
mm
In
Die Set
Assembly
Complete Tool
71256-0001 4.83-5.51 .190-.217 62100-0101 62100-0100
DESCRIPTION
The die set is designed to be used with the Hand Tool Frame Order No.
11-31-6379. The die set is designed to crimp LFH ferrule Order No.
71256-0001 on to a LFH cable assembly.
HAND TOOL
FRAME
INSTALLATION
The hand tool frame comes with the die set installed already installed.
If the die set needs to be replaced, follow the steps below:
Figure 1
M4 BHCS
Figure 2
FERRULE
CRIMP PUNCH
LARGE NEST
FERRULE
CRIMP ANVIL
MOVING JAW
1. Select the
DIE SET
proper die set.
2. Remove the two (2) M4 screws.
3. Slide the die set into the tool frame with the larger
crimp nest toward the frame’s jaws and the crimping
anvil going into the moving jaw. See Figure 2.
4. Close the jaws.
5. Reinstall the two (2) M4 screws and tighten securely.
Doc No: ATS-621000100 Release Date: 06-22-99
Revision: B
Revision Date: 03-12-09
UNCONTROLLED COPY
Page 1 of 4