WC415_12 Datasheet, PDF (2/2 Pages) MMD Components – WC415 Series Crystal

Mechanical Details
1.60 [.063] 0.90 [.035]
MAX
MAX
4.20 [.165]
MAX
1.30 [.051]
2.70 [.106]
DIMENSION IN BRACKETS ARE IN INCHES
1.90 [.075]
1.10 [.043]
3.3 [.13] 2.30 [.091]
1.10 [.043]
SUGGESTED LAND PATTERN
*DO NOT DESIGN ANY PATTERNS ON
SHADED AREA
Tape & Reel
PITCH
Tape Width
REEL DIA
Q1 Q2
Q3 Q4
Q1 Q2
Q3 Q4
DIRECTION OF FEED
PITCH
TAPE WIDTH
REEL DIA
QTY PER REEL
PIN 1 ORIENT.
4.00 [.157]
12.00 [.471]
330 [13.0]
3000
Q1
NOTES: UNLESS OTHERWISE SPECIFIED
1. Applicable Standards / Specifications
ANSI Y14.5M, Dimensions and Tolerances
EIA-481-B, 8 mm through 200mm Embossed Carrier Taping and 8 mm and 12 mm
Punched Carrier Taping of Surface Mount Components for Automatic Handling.
2. Dimensions are in millimeters [inch].
3. Tolerances are ±0.1 [.004] mm unless otherwise specified.
4. Do not scale drawing.
MMD Monitor/Quartztek
30400 Esperanza, Rancho Santa Margarita, CA, 92688
Phone: [phone], Fax: [phone], www.mmdcomp.com
[e-mail]
Specifications are subject to change without notice.
Revision:
11/08/10 D
Pg 2 of 2