MM1034 Datasheet, PDF (2/6 Pages) Mitsumi Electronics, Corp. – HBS-Compatible Driver and Receiver with Power Supply

MITSUMI
HBS-Compatible Driver and Receiver with Power Supply MM1034
Absolute Maximun Ratings ^(Ta=25°C)
Item
Storage temperature
Operating temperature
Power supply current
Operating power supply voltage
Allowable loss
Symbol
TSTG
TOPR
VCC max.
VCCOP
Pd
Ratings
-40~+125
-20~+75
-0.3~+46
13~45
400
Units
°_C
°_C
V
V
mW
Electrical Characteristics ^{(Except where noted therwise, Ta=25°C, VCC=30V, Ftransmit=10kHz (DUTY=50%))}
Item
Symbol
Output voltage
VO1
Output voltage
VO2
Output voltage
VO2
Output ripple voltage Vr
Reactive current
ICCO
SWR
SWR transmission
FOSC
frequency
Power supply current
IIS
on short-circuit
Output current
IOS
on short-circuit
Transmission output voltage VTO
Transmission
VTR
waveform symmetry
Reception sensitivity VRS
Noise resistance
VRN
Input impedance
RIN
Transmission delay time 1 Td1
Transmission
Transmission delay time 2 Td2
circuit _{Transmission delay time 3 Td3}
Transmission delay time 4 Td4
Reception output H voltage VROH
Reception output L voltage VROL
Transmission waveform LOSS 1 VTLS
Transmission waveform LOSS 2 VTLS
H level input voltage VLIH
L level input voltage VLIL
H level input current ILIH
L level input current
ILIL
Measurement conditions
VCC1=15~45V, IL=0~250mA
VCC1=13~45V, IL=0~250mA
VCC1=11~45V, IL=0~100mA
IL=250mA, no spikes
IL=0mA, transmit unit off
RS=0.2Ω
RS=0.2Ω
Both pins 8 and 9
VTO1/VTO2
Level at which no errors are output
Both pins 11 and 12
cf. transmit/receive waveform diagrams
cf. transmit/receive waveform diagrams
cf. transmit/receive waveform diagrams
cf. transmit/receive waveform diagrams
VT=5V applied, power on
applied, power off
VIN=2.4V
VIN=0.4V
Min.
4.75
4.70
4.75
70
3.8
0.75
0.65
0.55
25
4.5
4.5
4.5
2.4
Typ. Max. Units
5.00 5.25 V
5.00 5.25 V
5.00 5.25 V
50 mV
4 6 mA
80
kHz
7.5 12 mA
110 150 mA
4.2 4.6 VP-P
1.0 1.25
0.75 0.85 VP-P
VP-P
36 46 kΩ
0.2
µS
0.4
µS
0.7
µS
1.0
µS
V
0.5 V
V
V
V
0.8 V
10 µA
300 µA
When a negative voltage is applied to pins 8 and 9, there should be no abnormal operation of internal circuits
between 0 and 6V. However, if a negative voltage exceeding -6V is applied, thyristor operation may result, so
it is recommended that an external clamping diode be added.