PS21564-P Datasheet, PDF (5/9 Pages) Powerex Power Semiconductors – Intellimod™ Module Dual-In-Line Intelligent Power Module 15 Amperes/600 Volts

MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21564-P
TRANSFER-MOLD TYPE
INSULATED TYPE
MECHANICAL CHARACTERISTICS AND RATINGS
Parameter
Mounting torque
Weight
Heat-sink flatness
Condition
Limits
Unit
Min.
Typ.
Max.
Mounting screw : M3
Recommended : 0.78 N·m 0.59
—
0.98 N·m
—
20
—
g
(Note 6) –50
—
100
µm
Note 6: Measurement point of heat-sink flatness
+–
Measurement location
3mm
Heat-sink side
–
+
Heat-sink side
RECOMMENDED OPERATION CONDITIONS
Symbol
Parameter
Condition
Recommended value
Min.
Typ.
Max.
VCC
Supply voltage
VD
Control supply voltage
VDB
Control supply voltage
∆VD, ∆VDB Control supply variation
tdead
Arm shoot-through blocking time
fPWM
PWM input frequency
IO
Allowable r.m.s. current
PWIN(on)
Applied between P-N
Applied between VP1-VNC, VN1-VNC
Applied between VUFB-VUFS, VVFB-VVFS, VWFB-VWFS
For each input signal, Tf ≤ 100°C
Tf ≤ 100°C, Tj ≤ 125°C
VCC = 300V, VD = VDB = 15V,
fPWM = 5kHz
P.F = 0.8, sinusoidal output
Tf ≤ 100°C, Tj ≤ 125°C (Note 7) ^{fPWM = 15kHz}
(Note 8)
0
13.5
13.0
–1
2.0
—
—
—
0.3
300
15.0
15.0
—
—
—
—
—
—
400
16.5
18.5
1
—
20
7.5
4.8
—
Allowable minimum input
PWIN(off) ^{pulse width}
200 ≤ VCC ≤ 350V,
13.5 ≤ VD ≤ 16.5V,
13.0 ≤ VDB ≤ 18.5V,
–20°C ≤ Tf ≤ 100°C,
Below rated current _0.5
—
—
Between rated current and
1.7 times of rated current
2.0
—
—
N-line wiring inductance less than Between 1.7 times and
10nH
(Note 9) 2.0 times of rated current
2.6
—
—
VNC
VNC variation
Between VNC-N (including surge)
–5.0
—
5.0
Note 7 : The allowable r.m.s. current value depends on the actual application conditions.
8 : The input pulse width less than PWIN(on) might make no response.
9 : IPM might not work properly or make response for the input signal with OFF pulse width less than PWIN(off).
Please refer to Fig.7.
Unit
V
V
V
V/µs
µs
kHz
Arms
µs
V
Sep. 2005