M37733M4BXXXFP Datasheet, PDF (27/30 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

GZZ–SH00–76B<84A0>
7700 FAMILY MASK ROM ORDER CONFIRMATION FORM
SINGLE-CHIP 16-BIT MICROCOMPUTER
M37733M4BXXXFP
MITSUBISHI ELECTRIC
Mask ROM number
Date:
Section head Supervisor
signature
signature
Customer
Company
name
Date
issued
Date:
Note : Please fill in all items marked
TEL
Responsible
officer
Supervisor
(
)
1. Confirmation
Specify the name of the product being ordered.
Three sets of EPROMs are required for each pattern (Check @ in the appropriate box).
If at least two of the three sets of EPROMs submitted contain the identical data, we will produce masks based on this data.
We shall assume the responsibility for errors only if the mask ROM data on the products we produce differ from this data.
Thus, the customer must be especially careful in verifying the data contained in the EPROMs submitted.
Checksum code for entire EPROM areas
(hexadecimal notation)
EPROM Type :
27512
(1) Set “FF16” in the shaded area.
(2) Address 016 to 1016 are the area for storing the data on
0000
0010
model designation and options.This area must be written
with the data shown below.
Details for option data are given next in the section
describing the STP instruction option.
Address and data are written in hexadecimal notation.
DATA
8000
32K
FFFF
Address
4D 0
33 1
37 2
37
3
33 4
33
5
4D 6
34
7
Address
Address
42
8 ^{Option data} 10
FF
9
FF A
FF
B
FF _C
FF
D
FF
E
FF
F
2. STP instruction option
One of the following sets of data should be written to the option data address (1016) of the EPROM you have ordered.
Check @ in the appropriate box.
STP instruction enable
0116 Address 1016
STP instruction disable
0016 Address 1016
3. Mark specification
Mark specification must be submitted using the correct form for the type of package being ordered fill out the appropriate
80P6N Mark Specification Form (for M37733M4BXXXFP) and attach to the Mask ROM Order Confirmation Form.
4. Comments