PS21964-4 Datasheet, PDF (1/10 Pages) Mitsubishi Electric Semiconductor – 600V/15A low-loss 5th generation IGBT inverter bridge for three phase DC-to-AC power conversion

PS21964-4
MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21964-4/-4A/-4C/-4W
TRANSFER-MOLD TYPE
INSULATED TYPE
INTEGRATED POWER FUNCTIONS
600V/15A low-loss 5^th generation IGBT inverter bridge for
three phase DC-to-AC power conversion
INTEGRATED DRIVE, PROTECTION AND SYSTEM CONTROL FUNCTIONS
• For upper-leg IGBTS :Drive circuit, High voltage high-speed level shifting, Control supply under-voltage (UV) protection.
• For lower-leg IGBTS : Drive circuit, Control supply under-voltage protection (UV), Short circuit protection (SC).
• Fault signaling : Corresponding to an SC fault (Lower-leg IGBT) or a UV fault (Lower-side supply).
• Input interface : 3V, 5V line (High Active).
• UL Approved : Yellow Card No. E80276
APPLICATION
AC100V~200V three-phase inverter drive for small power motor control.
Fig. 1 PACKAGE OUTLINES (PS21964-4)
A
B
38 ±0.5
20×1.778(=35.56)
0.28
35 ±0.3
1.778 ±0.2
16-0.5
17
1
2-R1.6
QR
Type name
Code _{Lot No.}
3 MIN
18
0.28
2.54 ±0.2
0.5
14×2.54 (=35.56)
25
8-0.6
4-C1.2
0.5
0.5
0.5
2.5 MIN
(2.656)
3.5
1.5 ±0.05
0.8
HEAT SINK SIDE
Dimensions in mm
TERMINAL CODE
1. NC
2. VUFB
3. VVFB
4. VWFB
5. UP
6. VP
7. WP
8. VP1
9. VNC *
10. UN
11. VN
12. WN
13. VN1
14. FO
15. CIN
16. VNC *
17. NC
18. NC
19. NC
20. N
21. W
22. V
23. U
24. P
25. NC
1.5 _MIN
HEAT SINK SIDE
(2.756)
(1.2)
DETAIL A
DETAIL B
*) Two VNC terminals (9 & 16 pin) are connected inside DIP-IPM, please connect either one to the 15V power supply GND outside and
leave another one open.
Aug. 2007