PS21963-ST_09 Datasheet, PDF (1/8 Pages) Mitsubishi Electric Semiconductor – Dual-In-Line Package Intelligent Power Module TRANSFER-MOLD TYPE INSULATED TYPE

PS21963-ST
MITSUBISHI SEMICONDUCTOR <Dual-In-Line Package Intelligent Power Module>
PS21963-ST
TRANSFER-MOLD TYPE
INSULATED TYPE
INTEGRATED POWER FUNCTIONS
600V/10A low-loss 5^th generation IGBT inverter bridge for
three phase DC-to-AC power conversion.
Open emitter type.
INTEGRATED DRIVE, PROTECTION AND SYSTEM CONTROL FUNCTIONS
• For upper-leg IGBTS : Drive circuit, High voltage high-speed level shifting, Control supply under-voltage (UV) protection.
• For lower-leg IGBTS : Drive circuit, Control supply under-voltage protection (UV), Short circuit protection (SC), Over temperature protection (OT).
• Fault signaling : Corresponding to an SC fault (Lower-leg IGBT), a UV fault (Lower-side supply) or an OT fault (LVIC temperature).
• Input interface : 3V, 5V line (High Active).
• UL Approved : Yellow Card No. E80276
APPLICATION
AC100V~200V inverter drive for small power motor control.
Fig. 1 PACKAGE OUTLINES
0.28
1.778 ±0.2
17
38 ±0.5
20×1.778 (=35.56 )
35 ±0.3
A
16-0.5
1
2-R1.6
QR
Type name
Code ^{Lot No.}
3 MIN
18
25
0.28
2.54 ±0.2
0.5
14×2.54 (=35.56)
8-0.6
0.5
0.5
0.5
4-C1.2
Dimensions in mm
B
(2.656)
3.5
1.5 ±0.05
0.8
HEAT SINK SIDE
2.5 MIN
TERMINAL CODE
1. (VNC)
2. VUFB
3. VVFB
4. VWFB
5. UP
6. VP
7. WP
8. VP1
9. VNC *
10. UN
11. VN
12. WN
13. VN1
14. FO
15. CIN
16. VNC *
17. NC
18. NW
19. NV
20. NU
21. W
22. V
23. U
24. P
25. NC
1.5min
HEAT SINK SIDE
(1.2)
(2.756)
DETAIL A
DETAIL B
*) Two VNC terminals (9 & 16 pin) are connected inside DIPIPM, please connect either one to the 15V power supply GND outside and
leave another one open.
QR Code is registered trademark of DENSO WAVE INCORPORATED in Japan and other countries.
Mar. 2009