M5M29F25611VP Datasheet, PDF (1/36 Pages) Mitsubishi Electric Semiconductor – MORE THAN 16,057 SECTORS (271,299,072 BITS) CMOS 3.3V-ONLY SERIAL READ FLASH MEMORY

MITSUBISHI LSIs
M5M29F25611VP
MORE THAN 16,057 SECTORS (271,299,072 BITS)
CMOS 3.3V-ONLY SERIAL READ FLASH MEMORY
DESCRIPTION
The MITSUBISHI M5M29F25611 is a CMOS Flash Memory
with AND type multi-level memory cells.
It has fully automatic programming and erase capabilities
with a single 3.3V power supply.
The functions are controlled by simple external commands.
To fit the I/O card applications, the unit of programming and
erase is as small as (2048+64) bytes.
Available sectors of M5M29F25611 are more than
16,057(98% of all sector address) and less than 16,384
sectors.
FEATURES
On-board single power supply(Vcc) :
Vcc=3.0V to 3.6V
Organization
AND Flash Memory :
(2048+64)bytes x (More than 16,057 sectors)
Data register : (2048+64)bytes
Multi-level memory cell:
2bit / per memory cell.
Automatic programming :
Sector program time : 2.5 ms typ.
System bus free
Address,data latch function
Internal automatic program verify function
Status data polling function
Automatic erase :
Single sector erase time : 1.0 ms typ.
System bus free
Internal automatic erase verify function
Status data polling function
Erase mode :
Single sector erase ((2048+64)byte unit)
Fast access time :
Serial read First access time : 50µs max.
Serial access time : 50ns max.
Low power dissipation :
ICC2 = 30mA typ. / 50mA max. (Read)
ISB2 = 30µA typ. / 50µA max. (Standby)
ICC3 = 20mA typ. / 40mA max. (Program)
ICC4 = 20mA typ. / 40mA max. (Erase)
ISB3 = 1µA typ. / 10µA max. (Deep standby)
Package : 48pin-TSOP(I) (12.0 x 20.0mm2)
PIN CONFIGURATION(TOP VIEW)
GND 1
Vcc 2
3
DQ0 4
DQ1 5
DQ2 6
DQ3 7
GND 8
NC 9
NC 10
NC 11
NC 12
NC 13
NC 14
NC 15
NC 16
Vcc 17
DQ4 ¹⁸
DQ5 19
DQ6 20
DQ7 21
SC 22
GND 23
GND 24
M5M29F25611VP
Outline 48P3R-B
48 GND
47 GND
46 NC
45
44 NC
43
42 NC
41 Vcc
40 NC
39 NC
38 NC
37 NC
36 NC
35 NC
34 NC
33 NC
32 GND
31 R/
30
29 DU
28
27 NC
26 Vcc
25 GND
Pin Description
Pin name
DQ0-7
Vcc note1
GND note1
R/
SC
NC
DU note2
Function
Input / Output
Chip enable
Output enable
Write enable
Command data enable
Power supply
Ground
Ready /
Reset
Serial clock
No connect
Don't Use
Note1:All Vcc and GND pins should be connected to
a common power supply and a ground, respectively.
Note2:Pin should not be connected to anything.
1
Rev.2.3.1 2001.2.2