GVA-123 Datasheet, PDF (4/5 Pages) Mini-Circuits – Monolithic Amplifier

Monolithic InGap HBT MMIC Amplifier
Characterization Test Circuit
GVA-123+
Fig 1. Block Diagram of Test Circuit used for characterization. (DUT soldered on Mini-Circuits Characterization test board TB-665+)
Gain, Return loss, Output power at 1dB compression (P1 dB) , output IP3 (OIP3) and noise figure measured using Agilent’s N5242A
PNA-X microwave network analyzer.
(R=16.5Ω)
Conditions:
1. Gain and Return loss: Pin= -25dBm
2. Output IP3 (OIP3): Two tones, spaced 1 MHz apart, 0 dBm/tone at output.
Recommended Application Circuit
Fig 2. Test Board includes case, connectors, and components soldered to PCB
(Cblock=0.001 µF, Cbypass=0.1 µF, R=16.5Ω)
Product Marking
V123
Notes
A. Performance and quality attributes and conditions not expressly stated in this specification document are intended to be excluded and do not form a part of this specification document.
B. Electrical specifications and performance data contained in this specification document are based on Mini-Circuit’s applicable established test performance criteria and measurement instructions.
C. The parts covered by this specification document are subject to Mini-Circuits standard limited warranty and terms and conditions (collectively, “Standard Terms”); Purchasers of this part are entitled
to the rights and benefits contained therein. For a full statement of the Standard Terms and the exclusive rights and remedies thereunder, please visit Mini-Circuits’ website at www.minicircuits.com/MCLStore/terms.jsp
Mini-Circuits^®
www.minicircuits.com P.O. Box 350166, Brooklyn, NY 11235-0003 [phone] [e-mail]
Page 4 of 5