MERA-7456 Datasheet, PDF (1/5 Pages) List of Unclassifed Manufacturers – Dual Matched MMIC Amplifiers

Surface Mount
Dual Matched MMIC Amplifiers
NE_M^W!_ERA-7456
50Ω High Dynamic Range DC to 1 GHz
Features
• Two matched amplifiers in one package
• InGaP HBT IF and RF amplifier
• frequency range, DC to 1 GHz, usable to 4 GHz
• high gain, 25.1 dB typ. at 100 MHz
• up to +19 dBm typ. output power at 100 MHz
• high IP3, +36 dBm at 100 MHz
• low noise figure, 2.7 dB typ.
• low thermal resistance
• transient protected
• patent pending
• useable as balanced and push pull amplifier
Applications
• cellular
• catv
• VHF & UHF communication
receivers & transmitters
CASE STYLE: DL1020
PRICE: $ 4.70 ea. QTY (25)
Electrical Specifications @25°C
Freq.^H
(GHz)
f_L-f_U
Gain, dB Typical
A1, A2
over frequency, GHz
0.1 1 2 3 4
Min.@
1GHz
Maximum Power
( dBm)
Output
(1 dB Comp.) Typ.
0.1 1.0 2.0 Min.@
GHz GHz GHz 0.1GHz
Input
(no
dmg.)
Dynamic Range
IP3
(dBm)
NF
Typ.
(dB) 0.1 0.5 1.0
Typ. GHz GHz GHz
DC-1 25.1 22.5 18.6 14.2 9.4 20 19 18.2 14.4 18
10 2.7 36 35 32
H _{Guaranteed specification DC-1GHz. Low frequency cutoff determined by external coupling capacitors.}
** Permanent damage may occur if any of these limits are exceeded.
These ratings are not intended for continuous normal operation. Reliability predictions and normal
operating conditions are applicable at current specified.
matching¹
VSWR Maximum
(:1) Rating**
Typ.
DC
Operating
Power
Thermal
Resistance
Amplitude
Unbalance
between
Phase
Unbalance
between
Pin 5, Pin 8
θjc,
2 amps
(dB)
2 amps
(deg.)
I P Current
Volt
typ.
DC-1 GHz 1-4 GHz DC-1 GHz 1-4 GHz
In Out mA mW ^(mA) Typ Min Max °C/W Typ. Max. Typ. Max. Typ. Typ.
1.3 2.0 130 700 80 4.8 4.3 5.3 120 0.1 0.3 0.1 — 0.6 1.0
1. For test method, see application note AN-60-032
Pin Connections
PORT
RF IN 1
1
RF OUT 1
8
RF IN 2
4
RF OUT 2
5
DC 1
8
DC 2
5
GROUND
2,3,6,7 and paddle
MTTF vs. Junction Temperature
1,000,000
100,000
10,000
1,000
100
10
Maximum Ratings²
Operating Case Temperature
-45°C to 85°C
Storage Temperature
-55°C to 100°C
2. See application note AN-60-032 for adequate heat sinking of paddle.
typical biasing configuration
Rbios Vcc
RFC
(opt)
1
80
100 120 140 160 180 200
Junction Temp. (˚C)
RF IN1
1
A1
8
Vd
RF OUT1
RF IN2
Vd
A2
4
5
RF OUT2
Outline Drawing
2,3,6,7
& PADDLE
RFC
(opt)
Rbios Vcc
Demo Board MCL P/N: TB-293
Suggested PCB Layout (PL-164)
Outline Dimensions
(
inch
mm
)
A BCD
— .193 .035 .236
— 4.90 0.90 6.00
E FGH
— .050 .017 .008
— 1.27 0.43 0.20
JK
— .024
— 0.60
L M N P Q R S wt.
— .050 .030 .270 .030 .110 .020 grams
— 1.27 0.76 6.86 0.76 2.79 0.51 .08
Mini-Circuits^®
INTERNET http://www.minicircuits.com
P.O. Box 350166, Brooklyn, New York 11235-0003 [phone] Fax [phone]
Distribution Centers NORTH AMERICA 800-654-7949 • 417-335-5935 • Fax [phone] • EUROPE 44-1252-832600 • Fax [phone]
Mini-Circuits ISO 9001 & ISO 14001 Certified
REV. OR
M94145
MERA-7456
ED-11699/8
WZ/TD/CP
040927