XP1042-QT Datasheet, PDF (4/5 Pages) Mimix Broadband – 12.0-16.0 GHz Power Amplifier QFN, 3x3mm

12.0-16.0 GHz Power Amplifier
QFN, 3x3mm
February 2008 - Rev 10-Feb-08
P1042-QT
App Note [1] Biasing - As shown in the Pin Designations table, the device is operated by biasing VD1,2,3 at 5.0V with 125, 125, 250 mA respectively.
It is recommended to use active bias to keep the currents constant in order to maintain the best performance over temperature. Depending on the
supply voltage available and the power dissipation constraints, the bias circuit may be a single transistor or a low power operational amplifier, with
a low value resistor in series with the drain supply used to sense the current. The gate of the pHEMT is controlled to maintain correct drain current
and thus drain voltage. The typical gate voltage needed to do this is -1.0V. Make sure to sequence the applied voltage to ensure negative gate bias
is available before applying the positive drain supply.
App Note [2] Board Layout - As shown in the board layout, it is recommended to provide 100pF decoupling caps as close to the bias pins as
possible, with additional 10µF decoupling caps.
Recommended Layout
Mimix Broadband, Inc., 10795 Rockley Rd., Houston, Texas 77099
Tel: [phone] Fax: [phone] mimixbroadband.com
Page 4 of 5
Characteristic Data and Specifications are subject to change without notice. ©2008 Mimix Broadband, Inc.
Export of this item may require appropriate export licensing from the U.S. Government. In purchasing these parts, U.S. Domestic customers accept
their obligation to be compliant with U.S. Export Laws.