M09207 Datasheet, PDF (2/2 Pages) Microsemi Corporation – K Band Waveguide Modulator

®
TM
K Band Waveguide Modulator (MO9207)
K Band Waveguide Modulator
M09207
Typical Performance
Characteristics
120
110
100
90
80
70
60
50
40
30
20
10
0
0
5
10
15
20
Peak PIN Diode Current (mA)
Modulation Characteristic
Modulator Driver
The modulation driver should be current limited to 50 mA
pulse current. For a drive current of 20 mA from a 50-ohm
modulator operating at 5 volts a 120-ohm resistor should
be inserted in series with the PIN diode.
On
On
+
0
Off
Off
Positive drive is applied to the solder pin on top of unit.
Ground is any metallic contact on the waveguide.
MO9207 K Band Waveguide
Modulator
0.820
(20.83)
Max.
Solder Pin
UG-595/U Flange
WR-42 Waveguide
0.875
(22.2)
1.30
Max.
(33.02)
4X 0.120
Thru
[3.05]
0.875
(22.2)
Dimensions are in inches (mm).
0.125 Max.
(3.18)
Flange mates with UG-595/U WR-42. Delivered with
grounded buss wire for ESD protection.
Copyright  2008
Rev: 2008-11-04
Microsemi
Microwave Products
75 Technology Drive, Lowell, MA. 01851, 978 -442-5600, Fax: [phone]
Page 2