USB0403C Datasheet, PDF (1/2 Pages) Microsemi Corporation – TVSarray ™ Series

8700 E. Thomas Road
Scottsdale, AZ 85251
Tel: [phone]
Fax: [phone]
USB0403C
thru
USB0424C
TVSarray ™ Series
DESCRIPTION (300 watt)
This 4 pin 1 line bidirectional ULTRA LOW CAPACITANCE array is
designed for use in applications requiring board level protection from
voltage transients caused by electrostatic discharge (ESD) as defined
by IEC 1000-4-2, electrical fast transients (EFT) per IEC 1000-4-4 and
effects of secondary lightning.
These arrays are used to protect 1 discrete line utilizing pins (1,4 and
2,3). The S0T-143 product provides board level protection from static
electricity and other induced voltage surges that can damage sensitive
circuitry.
These TRANSIENT VOLTAGE SUPPRESSOR (TVS) Diode Arrays protect 3.3 Volt components such as
DRAM’s, SRAM’s, CMOS, HCMOS, HSIC, and low voltage interfaces up to 24Volts.
FEATURES
• Protects 3.3 up through 24V Components
• Protects 1 line bidirectional
• Provides electrically isolated protection
• SOT-143 Packaging
• ULTRA LOW CAPACITANCE 5 pF
MECHANICAL
• Molded SOT-143 Surface Mount
• Weight: .035 grams (approximate)
• Body Marked with device marking
code
• Pin #1 defined by DOT on top of
package
MAXIMUM RATINGS
• Operating Temperatures: -55⁰C to +150⁰C
• Storage Temperature: -55⁰C to +150⁰C
• Peak Pulse Power: 300 Watts (8/20 µsec, Figure 1)
• Pulse Repetition Rate: <.01%
PACKAGING
• Tape & Reel EIA Standard 481-1-A
• 13 inch reel 10,000 pieces
ELECTRICAL CHARACTERISTICS @ 25⁰C Unless otherwise specified
PART
NUMBER
DEVICE
MARKING
STAND
OFF
VOLTAG
E
VWM
VOLTS
MAX
BREAKDOWN
VOLTAGE
VBR
@1 mA
VOLTS
MIN
CLAMPING
VOLTAGE
VC
@ 1 Amp
(FIGURE 2)
VOLTS
MAX
CLAMPING
VOLTAGE
VC
@ 5 Amp
(FIGURE 2)
VOLTS
MAX
STAND OFF
CURRENT
ID
@ VWM
µA
MAX
USB0403C
U3
3.3
4
8
11
200
USB0405C
U5
5.0
6.0
10.8
13
100
USB0412C
U12
12.0
13.3
19
26
1
USB0415C
U15
15.0
16.7
25
32
1
USB0424C
U24
24.0
26.7
44
57
1
CAPACITANCE
(f=1 MHz)
@0V
C
pF
MAX
5
5
5
5
5
TEMPERATURE
COEFFICIENT
OF VBR
áVBR
mV/°C
MAX
-5
3
10
13
30
NOTE: Transient Voltage Suppression (TVS) product is normally selected based on its stand off Voltage
V_WM. Product selected voltage should be equal to or greater than the continuous peak operating voltage of
the circuit to be protected.
MSC0987.PDF
ISO 9001 CERTIFIED
REV D 1/14/2000