UM2100_09 Datasheet, PDF (1/6 Pages) Microsemi Corporation – ATTENUATOR AND POWER PIN DIODES 2 – 30 MHz

UM2100
®
TM
ATTENUATOR AND POWER PIN DIODES
2 – 30 MHz
RoHS Compliant Versions Available
DESCRIPTION
UM2100 Series PIN diodes are designed for transmit/receive switch
and attenuator applications in HF band (2-30MHz) and below. As
series configured switches, these long lifetime (25μs typical) diodes
can control up to 2.5 kW, CW in a 50 ohm system. In HF band,
insertion loss is less than 0.25dB and isolation is greater than 32dB
(off-state).
The UM2100 series offers the lowest distortion performance in both
transmit and receive modes. Less than 50 mA forward bias is requires
to obtain an IP3 of 60 dBm at 300 kHz with 1 watt per tone. The
forward biased resistance/reactance vs. frequency characteristics are
flat down to 10 kHz. The capacitance vs. reverse bias voltage
characteristic is flat down to 2 MHz. In attenuator configuration, the
UM2100 produces extremely low distortion at low values of attenuator
control current, and very low insertion loss (0.2dB) in the “0dB”
attenuator state.
IMPORTANT: For the most current data, consult our website: www.MICROSEMI.com
KEY FEATURES
 HF band (2-30 MHz) PIN
 Long Lifetime (25μs typical)
 High Power ( 1kW, CW)
 High Isolation (32dB)
 Low Loss (0.25dB)
 Very Low Distortion
(IP3=60dBm)
 Voltage ratings to 1000 V
 RoHS compliant packaging
Available¹
(use UMX2101B, etc.)
ABSOLUTE MAXIMUM RATINGS AT 25º C
(UNLESS OTHERWISE SPECIFIED)
Package
Conditions
(P_D ) Power
Dissapation
(W)
( Θ )Thermal
Resistance
( ^OC/W)
A
25 ^OC Pin Temperature
25
50V
B
½ in. total length to 25 ^OC
12
12.5
E
Contact Free Air
2.5
C
25 ^OC Stud Temperature
25
6
D
25 ^OC Stud Temperature
18.75
8
SM
25 ^OC End Cap Temperature
15
10
ALL
1 us pulse (Single)
100KW
ALL
Storage Temperature (T_OP)
ALL
Operating Temperature (T_OP)
-65 ^OC to + 175 ^OC
-65 ^OC to + 175 ^OC
1 _{The UM2100 series of products can be}
supplied with a RoHS compliant finish
(UMX2100) or with a 90/10 Sn/Pb finish.
Consult factory for details.
APPLICATIONS/BENEFITS
 Isolated stud package available
 Surface mount package available
 Soldering temperature:
260 ^oC for 10 seconds
maximum
Copyright  2007
Rev: 2009-01-19
Microsemi
Microwave Products
75 Technology Drive, Lowell, MA. 01851, 978-442-5600, Fax: [phone]
Page 1