LCV01-6 Datasheet, PDF (1/2 Pages) Microsemi Corporation – Bidirectional TVS Array

SCOTTSDALE DIVISION
LCV01-6
Bidirectional TVS Array ™
DESCRIPTION
This 16 pin one-line pair, bi-directional, LOW CAPACITANCE array is designed for
use in applications where protection is required at the board level. It provides
protection from voltage transients caused by electrostatic discharge (ESD) as
defined in IEC 61000-4-2, electrical fast transients (EFT) per IEC 61000-4-4 and
effects of secondary lightning as stated by IEC 61000-4-5.
These TRANSIENT VOLTAGE SUPPRESSOR (TVS) arrays have a peak pulse
power rating of 1500 watts for a 10/1000 µsec pulse and are designed to be used for
secondary surge protection on high-speed telecommunications lines. This device
can be used in either common or differential mode applications. It is typically used
between Tip and Ring. Applications include T1/E1 and DSL interfaces in base
stations, routers, and long-haul transient immunity requirement per Bellcore 1089,
FCC Part 68 (type A and B surges and IEC 61000-4-5
IMPORTANT: For the most current data, consult MICROSEMI’s website: http://www.microsemi.com
TVSARRAY™
FEATURES
• 1500 watts peak pulse power
• Protects one-line pair
• Provides electrically isolated protection
• SO-16W package
• UL 94V-0 flamability classification
• LOW CAPACITANCE 90 pF per line pair
APPLICATIONS / BENEFITS
• T1/E1 line cards
• Base stations
• WAN interfaces
• XDSL interfaces
• CSU/DSU equipment
MAXIMUM RATINGS
• Operating temperature: -55°C to +150°C
• Storage temperature: -55°C to +150°C
• Peak pulse power: 1500 watts (10/1000 µs, Fig 1)
• Pulse repetition rate: < .01%
• Thermal resistance:< 30°C/watt (junction-to-case)
• Lead soldering temperature: 260°C, 10s maximum
MECHANICAL AND PACKAGING
• Molded SO-16W Surface Mount
• Weight 0.25 grams (approximate)
• Marking: Logo, device marking code, date code
• Pin #1 defined by dot on top of package
• Tape & Reel per EIA Standard 481
• 13 inch reel; 2,500 pieces (OPTIONAL)
• Carrier tubes; 45 pcs (STANDARD)
ELECTRICAL CHARACTERISTICS PER LINE PAIR @ 25°C Unless otherwise specified
PART
NUMBER
DEVICE
MARKING
STAND OFF
VOLTAGE
VWM
VOLTS
MAX
BREAKDOWN
VOLTAGE
VBR
@1 mA
VOLTS
MIN
CLAMPING
VOLTAGE
VC
@ 100 Amp
(Figure 2)
VOLTS
MAX
CLAMPING
VOLTAGE
VC
@ 200 Amp
(Figure 3)
VOLTS
MAX
STANDBY
CURRENT
ID
@ VWM
µA
MAX
CAPACITANCE
(f=1 MHz)
C
@0V
pF
TYP
LCV01-6
LCV01-6
6.0
8.0
15
21
25
90
Note: Transient Voltage Suppressor (TVS) product is normally selected based on its stand off voltage V_WM. Product selected
voltage should be equal to or greater than the continuous peak operating voltage of the circuit to be protected.
Copyright © 2003
5-30 2003 REV A
Microsemi
Scottsdale Division
8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, [phone], Fax: [phone]
Page 1