66266 Datasheet, PDF (1/2 Pages) Micropac Industries – Base lead provided for conventional transistor biasing

66266
05/31/2013
6 PIN GULL WING
PROTON RADIATION TOLERANT OPTOCOUPLER
WITH 850 nm LED
OPTOELECTRONIC PRODUCTS
DIVISION
Features:
 High Reliability
 Base lead provided for conventional transistor
biasing
 Rugged package
 Stability over wide temperature
 +1000 V electrical isolation
Applications:
 Eliminate ground loops
 Level shifting
 Line receiver
 Switching power supplies
 Motor control
DESCRIPTION
The 66266 is a single channel device electrically similar to the 4N49. This product has been designed to be more tolerant to
proton radiation and uses an 850 nm LED for higher CTR and greater durability. The 66266 optocoupler is packaged in a
hermetically sealed 6 pin gull wing package. This device can be supplied to customer specifications as well as tested and
screened to the requirements of MIL-PRF-19500 up to space (JANS) level.
ABSOLUTE MAXIMUM RATINGS
Input to Output Voltage .......................................................................................................................................................... 1 kV
Emitter-Base Voltage ............................................................................................................................................................... 7 V
Collector-Emitter Voltage (Value applies to emitter-base open-circuited & the input-diode equal to zero) ........................ 70 V
Collector-Base Voltage .......................................................................................................................................................... 70 V
Reverse Input Voltage ............................................................................................................................................................ 7 V
Input Diode Continuous Forward Current at (or below) 25°C Free-Air Temperature (see note 1) .................................. 50 mA
Peak Forward Input Current (Value applies for tw 1 s, PRR < 300 pps) ........................................................................... 1 A
Continuous Collector Current ............................................................................................................................................. 50 mA
Continuous Transistor Power Dissipation at (or below) 25^C Free-Air Temperature (see Note 2) ............................... 300 mW
Storage Temperature......................................................................................................................................... -65°C to +125°C
Operating Free-Air Temperature Range ............................................................................................................-55°C to +125°C
Lead Solder Temperature (10 seconds max.) .................................................................................................................. 240°C
Notes:
1. Derate linearly to 125°C free-air temperature at the rate of 0.50 mA/°C above 25°C.
2. Derate linearly to 125°C free-air temperature at the rate of 3 mW/°C above 25C.
PIN 1
Package Dimensions
0.350±0.010
0.195
6X 0.015±0.002
Schematic Diagram
K1
6E
0.130
4X 0.050
4C
0.046±0.010
A3
5B
26° NOM.
0.025
0.008 MAX.
0.010
ALL DIMENSIONS ARE IN INCHES UNLESS OTHERWISE NOTED.
ALL TOLERANCES ARE ±0.005 UNLESS OTHERWISE NOTED.
A - ANODE
B - BASE
C - COLLECTOR
E - EMITTER
K - CATHODE
Micropac Industries cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. OPTOELECTRONIC PRODUCTS DIVISION  725 E.Walnut St., Garland, TX 75040  [phone]  Fax [phone]
www.micropac.com E-MAIL: OPTOSALES @ MICROPAC.COM