66058 Datasheet, PDF (1/2 Pages) Micropac Industries – SINGLE/DUAL CHANNEL, LOW-INPUT CURRENT,OPTOCOUPLER (Electrically similar to 6N140)

66058
SINGLE/DUAL CHANNEL, LOW-INPUT CURRENT,
OPTOCOUPLER (Electrically similar to 6N140)
Mii
OPTOELECTRONIC PRODUCTS
DIVISION
Features:
• DSCC Approved 8978501PX (Dual) and
8981001PX (Single)
• High current transfer ratio: 1000% typical
• 1500 Vdc isolation test voltage
• Low input current requirement: 0.5mA
Applications:
• Telephone ring detection
• Voltage level shifting
• Isolated receiver input
• Communication systems
• Medical systems
DESCRIPTION
The 66058 single/dual optocoupler utilizes infrared LEDs optically coupled to high gain photodarlington detectors. This unique
optocoupler provides high CTR and low leakage current over the full military temperature range (-55^° to +125°C). The 66058
is a 8 pin dual-in-line, hermetically sealed package and is available in standard and screened versions or tested to customer
specifications.
ABSOLUTE MAXIMUM RATINGS
Storage Temperature........................................................................................................................................... -65°C to +150°C
Operating Free-Air Temperature Range ............................................................................................................. -55°C to +125°C
Lead Solder Temperature.........................................................................................260°C for 10s (1.6mm below seating plane)
Peak Forward Input Current (each channel) ................................................................................................ 20mA (1ms duration)
Average Forward Input Current ........................…............(see Note 1) ...............................................................................10mA
Reverse Input Voltage ...............................................................................................................................................................5V
Output Current - I_O (each channel) ......................................................................................................................................40mA
Output Power Dissipation (each channel) ........................(see Note 2) ..............................................................................50mW
Supply Voltage - V_CC ..........................................................(see Note 3)........................................................................0.5 to 20V
Output Voltage - V_O (each channel).……........................(see Note 3) ...................................................................... -0.5 to 20V
Package Dimensions
Schematic Diagram
REAR VIEW
PIN ONE
0.370 [9.040]
0.390 [9.90]
87 65
YYWW
USA
XXXX
1 2 34
TYPE NUMBER
DATE CODE
NC 1
A2
K3
NC 4
8 Vcc
7 EN
6 V0
5 GND
0.320 [8.13]MAX
0.280 [7.11]
0.310 [7.88]
0.007 [0.18]
0.013 [0.33]
PIN ONE
0.90 [2.28]
0.110 [2.80]
0.170 [4.32]MAX
0.020 [0.51] MIN
.020 [0.51] MAX
SIDE VIEW
END VIEW
ALL DIMENSIONS ARE IN INCHES [MILLIMETERS]
A1
K2
K3
A4
8 Vcc
7 V01
6 V02
5 GND
Notes:
1. Derate I_F at 0.33 mA/°C above 110°C.
2. Collector output power plus one half of the total supply power is total output power. Derate at 1.66mW/°C above 110°C.
3. The lowest total I_OH over temperature is developed by keeping V_CC as low as possible, but greater that 2 volts. The
negative voltage at the detector side should be applied to Pin 10.
MICROPAC INDUSTRIES, INC. OPTOELECTRONIC PRODUCTS DIVISION • 725 E. Walnut St., Garland, TX 75040 • [phone] • Fax [phone]
www.micropac.com E-MAIL: [e-mail]
3 - 36