HAL101JQ-I Datasheet, PDF (5/12 Pages) Micronas – Hall-Effect Switch IC Family

DATA SHEET
HAL 1xy
1.2. Marking Code
All Hall sensors have a marking on the package
surface (branded side). This marking includes the
name of the sensor and the temperature range.
Type
HAL 101
HAL 102
HAL 103
HAL 104
HAL 106
HAL 107
HAL 108
HAL 109
Temperature Range
I
C
101I
101C
102I
102C
103I
103C
104I
104C
106I
106C
107I
107C
108I
108C
109I
109C
1.3. Operating Junction Temperature Range
The Hall sensors from Micronas are specified to the
chip temperature (junction temperature T_J).
I: T_J = −20 °C to +125 °C
C: T_J = 0 °C to +85 °C
Hall Sensor Package Codes
HALXXXPA-T
Temperature Range: I
Package: TQ for SOT89B-3
JQ for TO92UA-6
Type: 1xy
Example: HAL102JQ-I
→ Type: 102
→ Package: TO92UA-6
→ Temperature Range: T_J = −20 °C to +125 °C
Hall sensors are available in a wide variety of packag-
ing versions and quantities. For more detailed informa-
tion, please refer to the brochure: “Hall Sensors.
Ordering Codes, Packaging, Handling”.
1.4. Solderability and Welding
Soldering
During soldering reflow processing and manual
reworking, a component body temperature of 260 °C
should not be exceeded.
Welding
Device terminals shall be compatible with laser and
electrical welding. Please, note that the success of the
welding process is subject to different welding parame-
ters which will vary according to the welding technique
used. A very close control of the welding parameters is
absolutely necessary in order to reach satisfying
results. Micronas, therefore, does not give any implied
or express warranty as to the ability to weld the com-
ponent.
1 V_DD
3
OUT
2, 4 GND
Fig. 1–1: Pin configuration
Micronas
April 8, 2009; DSH000150_001EN
5