HAL805-1 Datasheet, PDF (17/30 Pages) Micronas – Programmable Linear Hall-Effect Sensor

DATA SHEET
HAL 805
3.2. Dimensions of Sensitive Area
0.25 mm x 0.25 mm
3.3. Position of Sensitive Areas
TO92UT-1/-2
x center of the package
y 1.5 mm nominal
Bd 0.3 mm
3.4. Absolute Maximum Ratings
Stresses beyond those listed in the “Absolute Maximum Ratings” may cause permanent damage to the device. This
is a stress rating only. Functional operation of the device at these conditions is not implied. Exposure to absolute
maximum rating conditions for extended periods will affect device reliability.
This device contains circuitry to protect the inputs and outputs against damage due to high static voltages or electric
fields; however, it is advised that normal precautions be taken to avoid application of any voltage higher than abso-
lute maximum-rated voltages to this circuit.
All voltages listed are referenced to ground (GND).
Symbol
Parameter
Pin No. Min.
Max.
V_DD
V_DD
−I_DD
V_OUT
Supply Voltage
Supply Voltage
Reverse Supply Current
Output Voltage
1
−8.5
8.5
1
−14.4^{1) 2)}
14.4^{1) 2)}
1
−
50¹⁾
3
−5⁵⁾
−5⁵⁾
8.5³⁾
14.4^{3) 2)}
V_OUT − V_DD Excess of Output Voltage
3,1
−
2
over Supply Voltage
I_OUT
Continuous Output Current
3
−10
t_Sh
Output Short Circuit Duration
3
−
T_J
Junction Temperature Range
−
−40
−40
10
10
170⁴⁾
150
N_PROG
Number of Programming Cycles
−
−
100
1)
2)
3)
4)
as
t<
as
t<
long as
10 min
long as
1000h
T_Jmax is not exceeded
(V_DDmin = −15 V for t <
T_Jmax is not exceeded,
1 min, V_DDmax = 16 V for t < 1 min)
output is not protected to external 14
V-line
(or
to
−14
V)
5) _{internal protection resistor = 100 Ω}
Unit
V
V
mA
V
V
mA
min
°C
°C
Micronas
Feb. 14, 2006; 6251-513-3DS
17