MAFA-1014-PA Datasheet, PDF (1/4 Pages) Emcore Corporation – Optical Preamplifier

MAFA 1014-PA Optical Preamplifier
Erbium Doped Fiber Preamplifier
DATASHEET | SEPTEMBER 2013
Applications
CATV Systems
Long Distance RF/Microwave Fiber
Optic Communication Links
Sensing and Control Systems
High-Performance Supertrunking Links
High Power Distribution Networks
Redundant Ring Architectures
FTTx Networks
Features
Full Function Fiber Optic pre-Amplifier
Low Noise Figure (NF Typ < 3.3 dB)
Pin > -45 dBm
Pout (saturated): ≈ +14 dBm
Small Signal Gain > 37 dB
Low Electrical Power Consumption
Output Isolation > 40 dB
Polarization Dependant Gain < 0.1 dB
Polarization Mode Dispersion < 0.2 ps
Output Return Losses < -40 dB
Output Residual Pump Power < -40 dBm
FIBER OPTICS
EMCORE’s MAFA 1014-PA Optical Preamplifier Erbium Doped Fiber Gain Block Module is
an ideal building block for system integrators to extend the fiber link for long-haul signal
transport. The MAFA 1014-PA Optical Preamplifier series gain blocks are designed to meet
the most demanding noise performance requirements of fiber optic communications and
control systems and performs all the functions required of an optical preamplifier for system
integration.
The MAFA 1014-PA Optical Preamplifier provides output optical isolation for stable, low
noise operation. The output optical signal power level is detected for monitoring and
control. The very low level input optical signal is amplified with active output power control
for constant current mode operation.
The compact mechanical footprint of the MAFA 1014-PA Optical Preamplifier allows using
this unit to be installed in small space environments.
General and Mechanical Specifications
Parameter
Min
Typ
Max Units
Operating Wavelength
1532
-
1565
nm
Operating Case Temperature
0
-
50
°C
Storage Temperature
-40
-
85
°C
Operating Humidity
20
-
85
%
Voltage Supply Range
-
+12/+5/+3.3
-
VDC
Optical Connectors
-
SC; FC; E2000
-
-
Dimensions (mm)
-
70 x 90 x 15
-
Mm
* - Extended temperature range of – 40ºC to +75ºC is also possible
** Transient Pulse to +X.X VDC + 5% for < 100 msec
Comments
Standard
Standard*
Standard
Non-condensing
All Versions**
User Specified
All Versions
Electrical power must be applied to the unit only after launching input optical
| REV 2013.09
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.