MT9V012 Datasheet, PDF (45/53 Pages) Micron Technology – 1/6-Inch VGA CMOS Digital Image Sensor

Preliminary^‡
MT9V012 - 1/6-Inch VGA CMOS Digital Image Sensor
Electrical Specifications
Electrical Specifications
Table 12: DC Electrical Characteristics: 2.50V–3.10V
VDD = 2.50V–3.10V; VAA = VAAPIX = 2.50V–3.10V; T_A = Ambient = 25°C
Symbol
VIH
VIL
IIN
VOH
VOL
IOZ
IPWRA
IPWRP
IPWRIOD
IPWRSIOD
IPWRA
Standby
IPWRP
Standby
IPWRIOD
Standby
IPWRSIOD
Standby
IPWRIOD
Standby
ClkOn
IPWRSIOD
Standby
ClkOn
Definition
Condition
Input High Voltage
Input Low Voltage
Input Leakage Current
No Pull-up Resistor;
VIN = VDD or DGND
Output High Voltage
Output Low Voltage
Tri-state Output Leakage Current
Analog Quiescent Supply Current Default settings
Pixel Array Quiescent Supply Current Default settings
Digital and I/O Quiescent Supply
Current, Default Mode
CLKIN = 27 MHz;
default settings
Digital and I/O Quiescent Supply
Current, Serial Mode
Analog Standby Supply Current
CLKIN = 27 MHz;
default settings
STANDBY = VDD1
Pixel Array Standby Supply Current STANDBY = VDD1
Digital and I/O Standby Supply
Current, Default Mode
Digital and I/O Standby Supply
Current, Serial Mode
Digital and I/O Standby Supply
Current with Clock On, Default
Mode
Digital and I/O Standby Supply
Current with Clock On, Serial Mode
STANDBY = VDD1,
CLKIN = 0 MHz
STANDBY = VDD1,
CLKIN = 0 MHz
STANDBY = VDD,
CLKIN = 27 MHz
STANDBY = VDD,
CLKIN = 27 MHz
Min
VPWR - 0.3
-0.3
-15
VPWR-0.2
TBD
TBD
TBD
TBD
0.0
0.0
0.0
0.0
0.0
0.0
Typ
25.76
1.39
2.5
2.5
TBD
TBD
TBD
TBD
TBD
Max
VPWR + 0.3
0.8
15
0.2
15
TBD
TBD
TBD
TBD
TBD
Units
V
V
µA
V
V
µA
mA
mA
mA
mA
µA
µA
µA
µA
µA
µA
Notes: 1. To place the chip in standby mode, first raise STANDBY to VDD, wait until FRAME_VALID
and LINE_VALID are de-asserted, then wait two master clock cycles before turning off the
master clock.
PDF: 814eb99f/Source: 8175e929
MT9V012_2.fm - Rev. B 2/05 EN
45
Micron Technology, Inc., reserves the right to change products or specifications without notice.
©2004 Micron Technology, Inc. All rights reserved.