B-XES Datasheet, PDF (3/3 Pages) Microdc power Technology Co., Ltd – Isolated 2W Single Output DC/DC Converters

B-XES&F-XES&H-XES Series
Output Specifications
Parameters
Voltage accuracy
Short Circuit protection
Short Circuit restart
Line voltage regulation (Single)
Load voltage regulation (Single)
Load voltage regulation (Single)
3.3V output model
Temperature coefficient
Ripple & Noise
Rising time
Conditions
Load 0 – 100%
Load 0 – 100%
At 20MHz
Bandwidth
Typical
±2
±0.5
±0.5
±1.5
±0.02
75
150
Maximum
Continuous
Auto-recovery
Units
%
%
%
%
%/℃
mV p-p
ms
General Specifications
Parameters
Conditions
Typical
Maximum
Units
Switching frequency
100% load
50
KHz
Operating temperature
Full Load without Derating
-40 to +85
℃
Storage temperature
-40 to +125
℃
Max Case temperature
90
℃
Cooling
Free air convection
%
Humidity
90
%
Case material
Plastic UL94-VO
Weight
3.8
g
Dimensions (L x W x H)
1.25 x 0.34 x 0.53 inches
31.80 x 8.60 x 13.47 mm
MTBF
>1 500 000 hrs (MIL-HDBK -217F, Ground Benign, t=+25 C)
NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltageand at rated output
load
unless otherwise specified
Pin Out Specifications
Pin
1000VDC
3000 and 6000VDC
1
+V Input
+V Input
2
N.C.
-V Input
3
N.C.
N.C.
9
N.C.
N.C.
10
-V Output
-V Output
11
+V Output
+V Output
12
-V Input
N.C.
Microdc Professional Power Module,Inc.
Tel:[phone] E-mail:[e-mail]
Website:http://www.microdc.cn
RoHS COMPLIANT INFORMATION
This series is compatible with RoHS soldering systems with a peak wave solder temperature
of 300°C for 10 seconds.
The pin termination finish on the SIP package type is Tin Plate, Hot Dipped over Matte Tin
with Nickel Preplate. The DIP types are Matte Tin over Nickel Preplate. Both types in this
series are backward compatible with Sn/Pb soldering systems.
REACH COMPLIANT INFORMATION
This series has proven that this product does not contain harmful chemicals, it also has
harmful chemical substances through the registration, inspection and approval.
http://www.microdc.cn Technical Enquiries-Email:[e-mail] Tel:[phone] Page 3 of 3