OCXOS Datasheet, PDF (1/2 Pages) MICORO CRYSTAL SWITZERLAND – Oven Controlled Crystal Oscillator

OCXOS Oven Controlled Crystal Oscillator
Sine Wave Output
12 V Power Supply
up to 20 MHz
FREQUENCY STABILITY
OVER:
OPERATING TEMP. RANGE : see note 1
LONG TERM AGING 1ST YEAR: < ±0.7 ppm *
10 YEARS: < ±4.0 ppm *
SUPPLY VOLTAGE ± 0.5 V
< ±0.1 ppm *
LOAD ±10%:
< ±0.01 ppm
POWER SUPPLY
SUPPLY INPUT:
INPUT CURRENT :
INPUT CURRENT :
Vcc = 12 V ±0.5 V *
< 25 mA @ +30 °C *
< 40 mA @ -20 °C *
FREQUENCY CONTROL RANGE
CONTROL VOLTAGE:
see note 2
FREQUENCY DEVIATION:
> ±4 ppm *
RESPONSE SLOPE:
positive
OUTPUT
OUTPUT SIGNAL:
HARMONICS:
SPURIOUS:
LEVEL:
LOAD:
Sine wave
-10 dBc *
-70 dBc *
> 1Vpp < 2Vpp
> 1kΩ // 5pF ±10%
ENVIRONMENT
OPERABLE TEMP. RANGE:
STORAGE TEMP. RANGE:
VIBRATION:
SHOCK:
PACKAGE:
PACKAGE HEIGHT:
WARM-UP
∆F/F:
CURRENT:
MISCELLANEOUS
SHORT TERM STABILITY:
PHASE NOISE (BW = 1Hz):
(typical, @ 10MHz in static
conditions)
-40 to +85 °C
-65 to +125 °C
10 to 2000 Hz / 10 g
2000 g, 0.3 ms, ½ sine
DIL 14, 4 pins, GND to case
8 mm
(see packaging info)
within spec after 30s @ 0°C *
< 250 mA during 10s
< 5 E-10 0.1 s to 30 s
Typical 5 E-11 @ 1 s
1 Hz : - 70 dBc / Hz
10 Hz : -100 dBc / Hz
100 Hz : -130 dBc / Hz
1 kHz : -140 dBc / Hz
* Customer’s specification on request
NOTE 1
TEMP. RANGE *
STABILITY *
TEMP. RANGE *
STABILITY *
TEMP. RANGE *
STABILITY *
OCXOS-AR1, AV5
0 to +60 °C
±0.05 ppm
(0.1 ppm peak to peak)
OCXOS-BR1, BV5
-20 to +70 °C
±0.1 ppm
(0.2 ppm peak to peak)
OCXOS-CR1, CV5
-40 to +85 °C
±0.2 ppm
(0.4 ppm peak to peak)
NOTE 2
ADJUSTMENT
WITH RESISTOR
(connected to ground)
INPUT IMPEDANCE
ADJUSTMENT
WITH VOLTAGE
INPUT IMPEDANCE
OCXOS-AR1, BR1, CR1
0 to 10 kΩ
> -4.7 kΩ
OCXOS-AV5, BV5, CV5
0 to 5 V
> 47 kΩ
MARKING EXAMPLE
OCXOS-BV5
20.000 MHz
01.25
12
Type
Frequency
(PIN 1)
Spec No.
Date Code
Piece No.
ORDERING INFORMATION EXAMPLE
O C X O S - B V 5 20 MHz x x x
Oscillator Type
OCXO = oven controlled
Crystal Oscillator
Oscillator Version
S = sine wave
Temperature Range
A = 0 to +60°C; +/-0.05ppm
B = -20 to +70°C: +/-0.1ppm
C = -40 to +85°C; +/-0.2ppm
X = custom spec.
N° of
customer
spec.
Oscillator output
frequency
Frequency Adjustment
R1 = external resistor
V5 = voltage 5V
Y = custom spec.
STANDARD FREQUENCIES (MHz)
10.0000
12.8000
16.0000
16.3840
19.4400
20.0000
DATE:
June 2003
Revision No.: 8
Page 1/2
In accordance with our policy of continuous development and improvement,
we reserve the right to modify the design or the specifications of our products without prior notice.
Headquarters:
Micro Crystal
Div. of ETA SA
Mühlestrasse 14
CH-2540 Grenchen
Switzerland
Tel.
Fax
Internet
Email
[phone]
[phone]
www.microcrystal.ch
[e-mail]