HCS360_11 Datasheet, PDF(9/40 Page) Microchip Technology – KEELOQ® Code Hopping Encoder outline and low cost,

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

HCS360_11 Datasheet, PDF (9/40 Pages) Microchip Technology – KEELOQ® Code Hopping Encoder outline and low cost,

◁

HCS360

3.5.8

SEED: ENABLE SEED

TRANSMISSION

If SEED = 0, seed transmission is disabled. The Inde-

pendent Counter mode can only be used with seed

transmission disabled since SEED_2 is shared with the

second synchronization counter.

With SEED = 1, seed transmission is enabled. The

appropriate button code(s) must be activated to trans-

mit the seed information. In this mode, the seed infor-

FIGURE 3-2:

Seed Transmission

All examples shown with XSER = 1, SEED = 1

When S[3:0] = 1001, delay is not acceptable.

CRC+VLOW SER_1

SEED_2

For S[3:0] = 0x3 before delay:

mation (SEED_0, SEED_1, and SEED_2) and the

upper 12 or 16 bits of the serial number (SER_1) are

transmitted instead of the hop code.

Seed transmission is available for function codes

(Table 3-9) S[3:0] = 1001 and S[3:0] = 0011(delayed).

This takes place regardless of the setting of the IND bit.

The two seed transmissions are shown in Figure 3-2.

SEED_1

SEED_0

Data transmission direction

16-bit Data Word

16-bit Counter

Encrypt

CRC+VLOW SER_1

SER_0

Encrypted Data

Data transmission direction

For S[3:0] = 0011 after delay (Note 1, Note 2):

CRC+VLOW SER_1

SEED_2

SEED_1

SEED_0

Data transmission direction

Note 1: For Seed Transmission, SEED_2 is transmitted instead of SER_0.

2: For Seed Transmission, the setting of DELM has no effect.

3.5.9

TMPSD: TEMPORARY SEED

TRANSMISSION

The temporary seed transmission can be used to dis-

able learning after the transmitter has been used for a

programmable number of operations. This feature can

be used to implement very secure systems. After learn-

ing is disabled, the seed information cannot be

accessed even if physical access to the transmitter is

possible. If TMPSD = 1 the seed transmission will be

disabled after a number of code hopping transmis-

sions. The number of transmissions before seed trans-

mission is disabled, can be programmed by setting the

synchronization counter (SYNC_A, SYNC_B) to a

value as shown in Table 3-5.

TABLE 3-5: SYNCHRONOUS COUNTER

INITIALIZATION VALUES

Synchronous Counter

Values

0000H

0060H

0050H

0048H

Number of

Transmissions

128

DS40152F-page 9

▷