PIC16C57CJW Datasheet, PDF (86/192 Pages) Microchip Technology – EPROM/ROM-Based 8-bit CMOS Microcontroller Series

PIC16C5X
13.6 Timing Diagrams and Specifications
FIGURE 13-2:
EXTERNAL CLOCK TIMING - PIC16CR54A
Q4
OSC1
CLKOUT
Q1
Q2
Q3
1
3
3
2
Q4
Q1
4
4
TABLE 13-1: EXTERNAL CLOCK TIMING REQUIREMENTS - PIC16CR54A
AC Characteristics
Standard Operating Conditions (unless otherwise specified)
Operating Temperature
0°C  TA  +70°C for commercial
–40°C  TA  +85°C for industrial
–40°C  TA  +125°C for extended
Param
No.
Symbol
Characteristic
Min Typ† Max Units
Conditions
FOSC External CLKIN Frequency⁽¹⁾ DC
—
4.0 MHz XT OSC mode
DC —
4.0 MHz HS OSC mode (04)
DC —
10 MHz HS OSC mode (10)
DC —
20 MHz HS OSC mode (20)
Oscillator Frequency⁽¹⁾
DC —
DC —
200 kHz LP OSC mode
4.0 MHz RC OSC mode
0.1 —
4.0 MHz XT OSC mode
4.0 —
4.0 MHz HS OSC mode (04)
4.0 —
10 MHz HS OSC mode (10)
4.0 —
20 MHz HS OSC mode (20)
5.0 —
200 kHz LP OSC mode
* These parameters are characterized but not tested.
† Data in the Typical (“Typ”) column is based on characterization results at 25C. This data is for design guid-
ance only and is not tested.
Note 1: All specified values are based on characterization data for that particular oscillator type under standard
operating conditions with the device executing code. Exceeding these specified limits may result in an
unstable oscillator operation and/or higher than expected current consumption.
When an external clock input is used, the “max” cycle time limit is “DC” (no clock) for all devices.
2: Instruction cycle period (TCY) equals four times the input oscillator time base period.
DS30453E-page 86
Preliminary
 1997-2013 Microchip Technology Inc.